Fellowes Paper Shredder 450Ms User Manual

®
POWERSHRED 450Ms  
Please read these instructions before use.  
Do not discard: keep for future reference.  
Quality Office Products Since 1917  
 
BASIC SHREDDING OPERATION  
PAPER/CARD OR CD  
1
2
3
Continuous operation:  
Up to 8-minutes maximum  
or  
NOTE: Shredder runs briefly after each pass to  
clear entry. Continuous operation beyond 8-minutes  
will trigger 15-minute cool down period.  
Plug in and  
turn ON (I)  
Feed paper/card  
straight into paper  
entry and release  
Hold CD at edge,  
feed into center of  
entry and release  
When finished  
shredding set to OFF (O)  
ADvANCED PRODUCT FEATURES  
SAFESENSE® TECHNOLOGY  
SafeSense® Technology  
Stops shredding immediately when hands touch the paper opening.  
Stops shredding immediately when  
hands touch the paper opening.  
SET-UP AND TESTING  
1
2
3
SilentShredTechnology  
Shreds without noisy disruptions  
®
Turn the shredder ON  
Touch test area and  
look for the SafeSense  
indicator to illuminate  
SafeSense is active and  
working properly  
®
®
(I) to activate SafeSense  
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com  
PRODUCT MAINTENANCE  
OILING SHREDDER  
CLEANING AUTO-START INFRARED SENSORS  
All micro-cut shredders require oil for peak performance. If not oiled, a  
machine may experience diminished sheet capacity, intrusive noise when  
shredding, and could ultimately stop running. To avoid these problems, we  
recommend you oil your shredder each time you empty your waste bin.  
Paper detection sensors are designed for maintenance free operation. However, on rare  
occasions the sensors may become blocked by paper dust causing the motor to run even if there  
is no paper present.  
(Note: two paper detection sensors are located in the center of the paper entry).  
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE  
TO CLEAN THE SENSORS  
1
2
1
4
2
3
Press and hold forward  
*Apply oil across entry  
Turn OFF (O) and  
unplug shredder  
Locate Auto-start  
infrared sensor  
Dip cotton swab in  
rubbing alcohol  
Using cotton swab, wipe  
away any contamination  
from the paper sensors  
(
) 2-3 seconds  
*Only use a non-aerosol vegetable oil in long  
nozzle container such as Fellowes 35250  
TROUBLESHOOTING  
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain  
illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery  
time for this shredder.  
SafeSense® Indicator: If hands are too close to the paper entry, the SafeSense® indicator will illuminate and the shredder will stop shredding.  
 
®
POWERSHRED 450Ms  
Declaration of Conformity  
Fellowes Manufacturing Company  
Yorkshire Way, West Moor Park, Doncaster, South Yorkshire, DN3 3FB, England declares that the product Model 450Ms conforms with the requirements of the Restriction of Hazardous Substances  
Directive (2011/65/EU), the Low Voltage Directive (2006/95/EC), the Electromagnetic Compatibility Directive (2004/108/EC), the WEEE directive (2002/96/EC), and below harmonized European  
EN Standards:  
Safety: EN 60950-1  
EMC Standard: EN55014-1  
Year Affixed: 12  
EN55014-2  
EN61000-3-2  
EN61000-3-3  
Itasca, Illinois, USA  
January 1, 2013  
James Fellowes  
W.E.E.E.  
This product is classified as Electrical and Electronic Equipment. Should the time come for you to dispose of this product please ensure that you do so in accordance with the European Waste of Electrical  
and Electronic Equipment (WEEE) Directive and in compliance with local laws relating to this directive.  
For more information on the WEEE Directive please visit www.fellowesinternational.com/WEEE  
LIMITED PRODUCT WARRANTY  
Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of additional costs incurred by Fellowes to provide parts or services outside of the country where the  
defects in material and workmanship and provides service and support for 2 years from the date shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF  
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION  
be free from defects in material and workmanship for 5 years from the date of purchase by the TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable  
original consumer. If any part is found to be defective during the warranty period, your sole and for any consequential or incidental damages attributable to this product. This warranty gives you  
exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide,  
part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product except where different limitations, restrictions, or conditions may be required by local law. For  
usage standards, shredder operation using an improper power supply (other than listed on more details or to obtain service under this warranty, please contact us or your dealer.  
label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any  
Australia Residents Only:  
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other  
reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.  
The benefits under Fellowes’ Warranty are in addition to other rights and remedies under a law in relation to the shredder.  
Questions or Concerns?  
Customer Service & Support  
Troubleshooting  
Troubleshooting  
Registration  
Replacement parts  
General questions  
Manuals  
Australia  
Europe  
+61-1-800-33-11-77  
00-800-1810-1810  
+44-(0)-1302-836800  
+1-800-955-0959  
United Kingdom  
United States  
©2013 Fellowes, Inc. Part No. 407316 Rev C  
 

Excalibur electronic Motorized Toy Car 9396 User Manual
Extron electronic Switch SW8 12 VGA User Manual
FieldServer Server FS 8700 128 User Manual
Fostex DJ Equipment LM16 User Manual
Frigidaire Dehumidifier 2020264A0525 User Manual
Fujioh Ventilation Hood 021 User Manual
Gardena Trimmer TS 350 User Manual
General Dynamics Network Hardware LT 3600 User Manual
GE Washer Dryer WSM2700R User Manual
GM Automobile Pontiac Aztek User Manual