JL Audio Car Speaker SB D MAG 10W3v3 User Manual

®
Stealthbox  
I N S TALLATI O N GUI DE  
START  
HERE  
for the  
SB-D-MAG/10W3v3  
(fits 2005-Up Dodge Magnum)  
STEP 1: Remove all contents from the dri-  
vers side rear cargo pocket.  
STEP 2: Remove the paper backing from the  
supplied wax square. Place the wax square 6”  
from the front wall and 2-1/2” from the  
left(outer) side wall.  
STEP 3: (a)Place the supplied Socket Cup  
Set Screw into the bottom of the  
Stealthbox®, leaving about 1/2” exposed.  
Make sure that the cup side of the screw is  
exposed to the outside.  
(b) Place the Stealthbox® into place. Press  
firmly down onto the enclosure.This is to  
make an impression on the wax square.  
Remove the Stealthbox®.  
If there is no impression on the wax square,  
back out the Socket Cup Set Screw further  
and repeat STEP 3:(b).  
This Stealthbox is a product which  
requires professional installation skills and  
tools.  
Please read this installation guide thor-  
oughly before beginning the project. It  
will guide you step by step through the  
installation. Several of the steps in this  
process may require two people to  
accomplish.  
It is absolutely vital that the enclosure  
be properly mounted to the vehicle  
according to these instructions. Failure  
to mount the enclosure properly pres-  
ents two problems: 1) The sub-bass  
performance will suffer due to the  
movement of the enclosure caused by  
the force exerted by the woofer(s) and  
2) A loose enclosure presents a serious  
safety hazard in the event of a collision  
or sudden deceleration.  
STEP 4:  
*CAUTIO N*  
STEP 5: Run speaker wire from the amplifi-  
ers location to the Stealthboxs® location.  
STEP 6: (a)Attach the speaker wire to the  
Stealthbox® terminal.  
Before drilling, make sure that you are not going to  
be drilling into any gas lines, brake lines, transmission  
lines, electrical wiring, transfer case(4x4 vehicles) or  
anything else that might cause a reduction in your  
weekly pay. Always wear eye protection when  
drilling.  
(b) Back out the Socket Cup Set Screw to  
expose 1-1/2”.  
With the use of a 1/2” drill bit and drill. Drill out  
the floor at the impression on the wax square.  
Please enjoy your JL Audio Stealthbox  
responsibly.  
Continued on Next Page  
SB-D-MAG/10W3v3, JL AUDIO, Inc 2006, Inc 2006  
Page 1  
Sheet SKU#011204 1/18/2006  
 

J A Henckels Baby Swing CDX P676 User Manual
JAI Security Camera VIS CAM 350 User Manual
Jet Tools Kitchen Utensil JMS 12SCMS User Manual
Juniper Networks Computer Hardware SSG 20 User Manual
JVC Flat Panel Television 0305TNH II IM User Manual
Kambrook Vacuum Cleaner KHV40 User Manual
Kenwood Stereo Receiver KR 596 User Manual
KitchenAid Ventilation Hood 36 914 cm 48 1219 cm Island Canopy Range Hood User Manual
Kodak Digital Camera CD1013 User Manual
Kompernass Laser Level KH 3006 User Manual