800-07760 10/10 Rev. A
Connecting LYNX Series Controls to the GSMX, GSMV or
7845GSMR Communications Device
Refer to the GSMX and LYNX PLUS, LYNXR-2 or LYNXR-I Installation Instructions for additional information
and procedures. If you are installing the Communications Device with a LYNX PLUS control, ensure that the
LYNXGSMEXTCB Cable Assembly is properly routed. If used, interconnecting wiring between the cable and
the communications device must not exceed 20ft in length.
Connecting the GSMX
1. Splice the stripped end of two LYNXGSMEXTCB Cable Assemblies (P/N 600-00151) to each other as shown in
Figure 1 and Table 1.
It is essential that the wires are spliced exactly as shown on Figure 1. If used, interconnecting wiring between
the two LYNXGSMEXTCB Cable Assemblies must not exceed 20ft in length.
2. Connect one end of the spliced LYNXGSMEXTCB Cable Assembly (P/N 600-00151) to the receptacle on GSMX as
shown in Figure 1.
3. Connect the other end of the spliced LYNXGSMEXTCB Cable Assembly (P/N 600-00151) to the communications
port on the LYNX PLUS, LYNXR-I or LYNXR-2 as shown in Figure 1. For the LYNX PLUS, ensure that the cable
is properly routed as shown on Figure 2.
Table 1 - Cable Assembly LYNXGSMEXTCB Splice Configuration
LYNX Series
GSMX
Yellow
Red
Green
Black
Red
Black
Green
Yellow
LYNX PLUS
10 11
Power Line
Carrier
Connector
Test
Button
Super Hi
Standard
Battery
Connectors
YELLOW
RED
GSM/GSML
Port
BLACK
GREEN
GSMX
CABLE ASSEMBLY
LYNXGSMEXTCB
(P/N 600-00151)
C I S S A L C L A S
YELLOW
GREEN
BLACK
RED
RED
1
2
3
4
BLACK
OR
YELLOW
GREEN
CABLE ASSEMBLY
LYNXGSMEXTCB
(P/N 600-00151)
SPLICE
GSM/GSML
Port
LYNXR-I /
LYNXR-2
SERIES
CABLE ASSEMBLY
LYNXGSMEXTCB
(P/N 600-00151)
RED
BLACK
YELLOW
GREEN
LYNXGSMEXTCB-001-V0
Figure 1. GSMX Connections
|