Havis Shields Automobile Accessories C TM IMP User Manual

INSTALL INSTRUCTIONS C-TM-IMP  
2000-2005 CHEVROLET IMPALA TRAK-MOUNT KIT  
TOOLS REQUIRED:  
Ratcheting Wrench  
Metric Socket Set  
Torx Bit Set  
Standard Socket Set  
Tape Measure  
HARDWARE:  
QTY DESCRIPTION  
PART#  
8
8
6
1
¼” x ¾” hex head bolt  
¼” Serrated nut  
¼” x 1” Hex head lag bolts  
32” Trak mount  
GSM33001  
GSM30023  
GSM33060  
CM93055-9  
SUB ASSEMBLY:  
1. MOUNT TRAK TO HUMP BRACKETS.  
Determine location that Trak will land on transmission hump for the specific  
application.  
With Trak in necessary location, measure Front and Rear Hump Brackets in relation  
to Trak.  
Bolt Trak to Hump Brackets, using measurements taken in previous step  
Note: There are 2 different sides to the Trak Plate. It is recommended to mount Hump brackets  
to side of Trak Plate that has ¼” hardware slots closer together, to better accept equipment,  
(consoles, control heads, etc)  
Slide (6) ¼-20 x ¾” Hex Head Bolts into ¼” Hardware Slots.  
With bolts in Trak, position Hump brackets.  
There is a left and right side to the Rear Hump Brackets. Top of brackets will be  
parallel to the transmission hump.  
Attach ¼” serrated nuts and tighten.  
TRAK-MOUNT ASSEMBLY  
(Image Upside down)  
Front Hump Bracket C-B17  
Rear Hump Bracket C-B27  
¼” Hardware Slots  
Trak  
 

Grindmaster Coffeemaker C 1S User Manual
Hamilton Beach Coffeemaker 45237R User Manual
Hawking Technology Network Card 202 10248 01 User Manual
Honeywell Network Card Series 90 User Manual
Hotpoint Freezer 4DB User Manual
HP Hewlett Packard Computer Monitor 1910 User Manual
HP Hewlett Packard Printer 2000CP 2500 User Manual
Huawei Router B160 User Manual
Hypertec Carrying Case N6628AHY User Manual
Ice O Matic Refrigerator ICE250 through ICE2100 SERIES User Manual