Haier Water Heater ES15V P2 User Manual

FAQ  
Phenomenon  
Remedy  
Spa Water Heater  
User's Manual  
No water supply or water pressure  
is too low  
Check  
No water  
Water use point is blocked or hot  
water valve is closed  
ES15V-P2  
ES25V-P2  
ES35V-P2  
Check and clear  
Check and open  
Hot water access close  
1
2
Temperature not set to desired Calibrate the heater according to the  
setting  
operation instructions in the manual  
Calibrate the heater by referring to  
the operation instructions in the  
manual  
Cold outlet water  
Heating time limit and setting  
temperature not obtain  
3
Contact with service department  
Defective elements  
4
1
when  
,
and are excluded.  
1
2
3
Whether the current function  
is set to the proper mode and  
temperature is set too low.  
Calibrate the heater according to the  
operation instructions in the manual  
Not heated to  
desired temperature  
water  
Excessive water pressure  
2
turned down  
Inconstant water pressure  
turned down or use with constant  
water pressure  
temperature of water  
No power to heater  
Defective elements  
Check power socket  
1
2
Incapable of startup  
or display not lit  
Contact with service department  
when is excluded.  
1
Display E1  
Display E2  
Faulty line  
Contact with service department  
Power on after disconnection when  
SPEED  
TIMER  
SET  
SPEED TIMER  
SET  
1
Contact with service department  
Defective elements  
2
1
when is excluded.  
1
Room temperature lower than  
-20°C  
when ambient temperature more  
than -19°C  
Display E3  
Contact with service department  
Defective sensor  
2
when is excluded.  
1
Please read this manual before usage.  
Retain it for future reference.  
0040502425  
V
Installation • Use  
Safety warning (Read carefully before use)  
Meanings of icons  
Installation  
These are matters  
for which attention  
is required  
CAUTION  
These are actions  
which must be  
carried out  
These are  
actions which  
are forbidden  
(Figure 1) for installation  
reference only.  
Forbidden  
Warning  
SPEED TIMER  
SET  
If the water heater emits an unusual  
smell or a burning smell, please  
disconnect the power supply  
Take care not to be scalded by hot water.  
Hot water  
outlet  
Safety valve  
Do not touch the valve and pipe for hot  
water supply.  
CAUTION  
Cold water  
inlet  
immediately and call the service center.  
Please feel the water temperature before  
use. Use only when the temperature is  
ideal for you.  
Shower  
This mark is the designation  
Hot  
Cold  
head  
water  
outlet  
valve  
Mixing  
Valve  
water  
for Pre-safe Expert of Haier  
outlet  
valve  
Water Heater Company,  
which indicates the use of  
Installation must be made by installers of or designated by our company after-service department.  
The water heater shall be wall-mounted.  
Make 2 holes Φ 12mm, 65mm deep in wall with an  
impact drill according to the drawing of the external  
dimensions (See Figure 4).  
the company's patented  
Do not set at outdoor places.  
technology inside the product. It ensures  
you a safe bath while monitoring whether  
your house ground wire is live or not all  
the time. If this mark is lit, it indicates your  
house ground wire was come live (poor  
grounding and live). In this case, please  
immediately stop use and disconnect  
the power, and remember not to touch  
any electric applicance in your house.  
At the same time, immediately contact  
after-sales service and your property  
management company for professional  
Forbidden  
Forbidden  
1
2
Wall rack  
Do not install the water heater in the  
conditions in which ice could form.  
Ice formation will cause the water  
container and piping to crack, leading  
to scalds and water leakage.  
Take out all accessories in packaging liner, unpack  
one hook, sleeve the ring end of the connection lines  
Expansion  
hook  
among the accessories into the hook tightening end  
and assemble the hook well.  
(Figure 2)  
Do not connect or disconnect the power  
supply while your hands are wet.  
3
4
Extended connection line  
Forbidden  
Warning  
right hole).  
Check if the ammeter and the  
diameter of the wires are in  
accordance with the rated current  
of the water heater. If necessary,  
please have it checked by an  
experienced electrician.  
Lift the water heater and hang it with wall rack corresponding to the two hooks. Insert the  
connection spacer led from the rear shell wall rack of the heater into the connection terminal  
of the line on the hook (See Figure 2).  
Non-professional maintenance  
personnel shall not carry out  
unauthorized repair, maintenance,  
dismantling or re-construction of  
the heater.  
appropriate locations on inlet and outlet pipes respectively. Find the location requiring hot  
water supply. Connect inlet pipe, outlet pipe and city water pipe respectively to the use point  
for hot water. Fill the tank with water to check whether there is any leakage. It must be re-  
connected if there are signs of water leakage.  
Forbidden  
Do not drink hot water from the  
heater or use it for similar purposes.  
Be sure to use independent socket  
and earth it reliably.  
Warning: Do not release your grip unless the wall rack is securely hung on the hook.  
Forbidden  
Forbidden  
Otherwise the heater may fall and cause personal injury or property damage.  
Earthing  
Do not spray water or steam onto  
the heater.  
In case the power cord of the  
water heater is damaged, be sure  
to have it replaced by after service  
technicians with special cord  
Installing safety valve  
Please take precautionary measures  
during cold weather so as to prevent  
the heater from being frozen.  
Connect the safety valve to the water inlet by following the direction of its arrow (the arrow  
should point towards the heater). The safety valve’s rated pressure is 0.80MPa and its connection  
is G1/2. Once power is connected and the water is being heated, the water inside the water  
tank will expand. In order to relieve the water pressure inside, a very  
(Figure 3)  
Warning  
Warning  
Warning  
If you do not need to use the heater  
for a prolonged period, please cut  
safety valve. The pressure-relief vent must be free of any blockages.  
reliable wall.  
Please connect the drain hose to the safety valve. Connect one end  
of the hose to the safety valve vent and the other end to the sewage  
drain. The hose can be cut short or extended as necessary. The hose  
CAUTION  
in the heater in accordance with  
the instructions in the chapter on  
cleaning and maintenance.  
Do not install at places without sewage.  
Connect to drain hose  
shall be installed as inclined downward.  
Forbidden  
1
2
 

Graco Stroller 1759703 User Manual
Haier Freezer HFH 50 User Manual
Hamilton Beach Blender Classic Chrome Blender User Manual
HannsG Computer Monitor JG191A User Manual
Harbor Freight Tools Indoor Fireplace 91797 User Manual
Heath Zenith Home Safety Product SL 5310 User Manual
Hotpoint Washer Dryer WDAL 9640 User Manual
HP Hewlett Packard Camera Accessories PhotoSmart User Manual
HP Hewlett Packard Vacuum Cleaner HP 8360 User Manual
Hubbell Electric Heater Company Water Heater SE User Manual