Quick Start Guide
JT02-37E1 37" Liquid Crystal Display TV
This guide is designed as a reference to help you start using your LCD TV quickly. Please refer to the User's Manual for more detailed installation and safety instructions.
Rear View
Front View
1
2
3
4
5
6
7
8 9
1
2
3
4
5 6
7
8 9 10 11 12
13
14
15
1. Volume down button
2. Volume up button
3. OSD Menu button
4. Channel down button
5. Channel up button
6. Enter button
7. Power button
8. Infrared receiver
9. Power LED indicator
1. AC power switch
2. AC power input
3. HDMI input terminal (19 pin)
4. D-Sub signal input (15 pin)
5. Audio Input for VGA
9. Audio input for YPbPr/ HD components (L/R)
10. Audio input for AV or S-Video components (L/R)
11. S-Video input
12. Audio output (L/R)
13. SCART1 input
6. Headphone jack
14. SCART2 / SCART2-SV input
7. YPbPr/ HD component video input 15. RF antenna / Cable TV input
8. Composite video input
Making Connections
Connecting to Antenna/Cable TV
Getting Started
Selecting Input Source
TV
AV
SV
HD
1. Connect one end of the UHF/VHF (Antenna)
or CATV cable to the TV IN jack (UHF/VHF IN
jack) on the back of the TV.
1. Make sure your TV is turned on and a device
such as a DVD player is connected.
2. Press the SOURCE button on the remote
HDMI
control and use the t / u button to select
the required input source between TV, AV,
SV, HD, SCART1, SCART2, SCART2-SV,
D-SUB, and HDMI.
2. Connect the other end of the UHF/VHF
(Antenna) or the CATV cable to the Antenna
or CATV socket.
D-SUB
SCART1
SCART2
SCART2-SV
Connecting to VCR,VCD or DVD Player
3. Press enter to confirm your selection.
The illustrations below show you how to connect your TV to a VCR, VCD or a DVD player.
With RCA AV cable
With S-Video cable
Auto Channel Scan
Follow the instructions below to automatically preset the channels for your TV
before watching it for the first time.
1. Press the "MENU" button on your remote control or the control panel.
2. Use the p / q button to select Channel Menu.
3. Press the t / u button to start Auto Scan.
Note: After performing Auto Scan, you need not do it again when turning
With YPbPr cable
With SCART1
on your TV next time.
Auto Scan
C h a n n e l
A u t o S c a n
M a n u a l S t o r e
N a m e
Connecting the Power Cord
1. Plug the power connector into the
AC-IN input jack on the rear cover of
the TV-set.
S o r t
2. Insert the three-pronged plug at the
other end of the power cord into a
power outlet.
OSD
S e l e c t
MENU E x i t
3. Turn the main power switch on to
supply power to the TV.
JT2002310621P
© Copyright 2006 Hannspree, Inc. All rights reserved.
|