JTP35SM
GE® 30" Built-In Double Wall Oven
Dimensions and Installation Information (in inches)
KW Rating
Cutout width
28-1/2'' MIN.
28-5/8'' MAX.
6.9
5.2
240V
208V
5
C
L
Cutout depth
23-1/2" MIN
2 x 4 or
equivalent
runners
Breaker Size
Junction box
location
E
30 Amps
30 Amps
240V
208V
A
B
Conduit
(72"
Note: Cabinets installed adjacent to wall ovens
must have an adhesion spec of at least a 194°F
temperature rating. Electric wall ovens are
not approved for installation with a plug
and receptacle. They must be hard wired in
accordance with installation instructions.
Suitable oven cabinet bracing must
support 275 lbs.
long)
47" to
Suitable
bracing
to support
runners
bottom of
21-5/8"
over centerline
of cabinet
junction box
Cutout height
51-13/16" MIN.
51-15/16" MAX.
(must support 325 lbs.)
D
A
Cabinet
30"
11/16"-3/4"
1"
n
21
A – Overlap of oven over side of edges of cutout
B – Overlap of oven at top and bottom of cutout
Oven
C – Overall depth*
D – Overall height with trim
Overall height without trim
E –Overall width
*Depth including door handle is approximately 26-6/10" min. to
26-9/10" max.
21" minimum
Door Opening
Allowance
Door handle protrudes 3" from door face.
Cabinets and drawers on adjacent 45° and 90°
walls should be placed to avoid interference with
the handle.
B
23-1/2"
53-3/8"
52-7/8"
29-3/4"
Minimum cutout location
12" from the floor.
C
Cabinet
width 30"
Installation Information: Before installing,
consult installation instructions packed with
product for current dimensional data.
MOST 30'' WALL CABINETS CAN BE USED WITH THIS UNIT.
THE OPENING BETWEEN THE INSIDE WALLS MUST BE AT LEAST 28-1/2'' WIDE.
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Listed by
Underwriters
Laboratories
Specification Revised 9/07
320146
|