GE Security
Installation/Operation Instructions
Warranty Information
VTPR1000
VTPR1000-R3
888-999-9IFS
Be sure to observe
polarities between
Manual Gain Control
transmitter and receiver
VTPR1000
UNSHIELDED TWISTED PAIR
VIDEO RECEIVER
WITH AGC
In From VTPT1000M Series
or any passive UTP
balun device.
- -- 2
+ -- 1
VIDEO IN
GAIN
CAT5 UTP
International
Fiber
COAX CABLE
Systems
VIDEO OUT
ifs
Incorporated
203.426.1180
POWER
- 2
+ 12 VDC - 1
Black
POWER
Black w/ White
Stripe 12 VDC
Connection
Video
Monitor
Product Disassembly Instructions for WEEE
Per European Directive 2002/95/EC Waste Electrical and
Electronic Equipment
Required Tools:
One number 2 Phillips (crosstip) screwdriver.
One number 2 flat screwdriver.
For the enclosed box version:
1. Locate and remove box cover securement screws. Usually, but not limited to, at least
4 screws.
2. Lift off box top cover.
3. Locate and remove securement screws for printed circuit board.
4. If there are multiple boards to the assembly, continue removing securement screws
until none are left.
5. Lift off printed circuit board.
6. Disassembly of box version of product is complete.
For rack version:
1. Locate and remove securement screws for printed circuit board. Usually, but not
limited to, at least 4 screws.
2. If there are multiple boards to the assembly, continue removing securement screws
until none are left.
3. Lift off printed circuit board(s).
4. Disassembly of rack card version of product is complete.
|