Instructions
Model Number 75973
Lift & Lock Swing
Please save these instructions for future reference.
No assembly is required.
For children 9 months - 3 years and up to 20 kg (45lbs).
Placement and
Play Area Surfacing
Before installing the Lift & Lock Swing, select and
prepare a play area.
Placement
Install the swing at least one meter (three feet) from any
structure or obstruction such as a tree trunk, fence,
garage, house, overhanging branches, laundry lines or
electrical lines.
Surfacing
Following are guidelines from the U.S. Consumer
Product Safety Commission’s Handbook for Public
Playground Safety to minimize injuries that can result
from falls. These guildelines apply to playground
equipment including but not limited to swing sets and
climbing equipment.
Hard surfacing materials are not suitable for use
under this equipment. Earth surfaces such as soils
and hard packed dirt are also not recommended
because their shock absorbing properties can vary
depending on climatic conditions such as moisture and
temperature. Grass and turf are not recommended
because their effectiveness in absorbing shock during
a fall can be reduced considerably due to wear and
environmental conditions.
Acceptable surfacing materials are available in two
basic types: loose-fill and unitary.
Loose-fill materials can have acceptable shock
absorbing properties when installed at sufficient
uncompressed depth of at least 15 cm (6 inches).
These materials include sand (fine and coarse), gravel
(fine and medium) and shredded wood products (wood
mulch, shredded bark, wood chips). Loose-fills should
not be installed over hard surfaces such as asphalt
or concrete.
The depth of any loose-fill material could be reduced
during use resulting in different shock-absorbing
characteristics. For this reason, a depth greater than
the minimum recommended should be considered.
Unitary materials are generally rubber mats or a
combination of rubber-like materials held in place
by a binder that may be poured in place at the
playground site and cures to form a unitary shock
absorbing surface.
3
Installation of the
Lift & Lock Swing
The Lift & Lock Swing can be attached to a swing set,
pole or tree branch.
IMPORTANT! When installing the Lift & Lock Swing,
be sure it cannot swing to within one meter (three feet)
of any other object in front of, behind, or to the side of it.
CAUTION
Periodically inspect S-hooks for wear.
Metal to metal contact between hooks
may cause premature wear. If your swing
set does not have a bushing, you may
want to replace the existing hook with a
hook and bushing assembly available at
toy stores and home centers.
Swing Set Installation
Swing Set
Hooks
(not included)
Bushing
(not included)
S-Hook
(included)
• Fasten the Lift & Lock Swing S-hooks (included) onto
the hooks (not included) on your swing set.
4
Installation of the
Lift & Lock Swing
Pole or Tree Branch Installation
Pole
Ropes
S-Hook
INPORTANT! Before installing, check the strength
and stability of the pole or tree branch. Place the
Lift & Lock Swing at least one meter (three feet)
from a tree trunk or any other structure.
• Wrap the S-hook end of the Lift & Lock Swing ropes
around the pole or tree branch.
• Hook the S-hook around the ropes. Pull down on
the ropes to make sure the Lift & Lock Swing is
securely fastened.
5
Securing Your Child
®
Restraint
Bar
Waist
Belt
®
Crotch
Belt
Release
Lever
• Pull the release lever toward you and raise the
restraint bar.
• Unbuckle the waist belts from the crotch belt.
• Place your child in the swing.
• Pull the crotch belt up between your child’s legs and
fasten both waist belts to the crotch belt. Make sure
you hear a “snap” on both ends.
• Insert the restraint bar down into the latch until it snaps
into place. Pull up on the restraint bar to be sure it is
securely latched.
B
Anchored End
Anchored End
Buckle
A
A
B
Free End
Free End
To Tighten
To Loosen
To tighten the waist belts:
• Feed the anchored end of the waist belt up through
the buckle to form a loop A. Pull the free end of the
B
waist belt
.
• Repeat this procedure to tighten the other waist belt.
To loosen the waist belts:
• Feed the free end of the waist belt up through the
A
buckle to form a loop . Enlarge the loop by pulling
on the end of the loop toward the buckle.
• Pull the anchored end of the waist belt to shorten the
B
free end of the waist belt
.
• Repeat this procedure to loosen the other waist belt.
6
Removing Your Child
®
Restraint
Bar
Release
Lever
• The release lever is located on the underside of the
swing seat. Squeeze the release lever toward the
front edge of the swing and lift the restraint bar. Slide
the restraint bar up.
• Squeeze tabs on the release buckles to unfasten the
crotch belt from the waist belt.
Helpful Hint: The restraint bar will remain in the up
position for ease in placing a child in or out of the
Lift & Lock Swing.
Cleaning
Wash the Lift & Lock Swing with a mild soap and water
solution. Rinse with clean water to remove soap residue.
Storage
Remove the Lift & Lock Swing from your swing set or
other location and store it indoors when the outdoor
temperature drops below freezing.
7
Three (3) Year Limited Warranty
Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag
#870, Richmond, Victoria 3121 Australia, warrants to the
original owner that the Lift & Lock Swing is free from all
defects in material and workmanship when used under
normal conditions for a period of three (3) years from the
date or purchase. This warranty does not cover the swing
ropes, color fading of the product or product parts, or
damage from excessive weather abuse or acts of God.
Should the product fail to perform properly, we will repair
or replace it at our option, free of charge. Purchaser is
responsible for shipping the product to Mattel Australia
Pty. Ltd. at the address indicated above and for all
associated freight and insurance cost. Mattel Australia
Pty. Ltd. will bear the cost of shipping the repaired or
replaced item to you. This warranty is void if the owner
repairs or modifies the product. This warranty excludes
any liability other than that expressly stated above
including but not limited to any incidental or
consequential damages.
SOME STATES DO NOT ALLOW THE EXCLUSION OR
LIMITATION OF INCIDENTAL OR CONSEQUENTIAL
DAMAGES, SO THE ABOVE LIMITATION MAY NOT
APPLY TO YOU.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL
RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS
WHICH MAY VARY FROM STATE TO STATE.
Consumer Information
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.
New Zealand: 16-18 William Pickering Drive, Albany 1331,
Auckland.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2001Mattel,Inc. All Rights Reserved.® and™designate U.S. trademarks of Mattel,Inc.
Printed in Australia
75973pr-0920
8
|