Opti Gel Cordless Mouse
INSTRUCTION GUIDE
1 INTRODUCTION
Congratulations on your purchase of one the worlds most innovate
mice, which includes the Wireless Optical Image Sensor for superior
performance on your PC.
The Opti Gel Cordless, incorporates revolutionary Radio Frequency and
Optical Sensor technologies and is equipped with the following
features:
• Increased accuracy: the optical image sensor records motions on the
mousing surface 1,500 times per second for pin point accuracy.
• Cordless freedom with a six-foot range from the receiver.
• 27 Mhz transmission with eight separate ID’s, to eliminate
interference with other RF devices.
• No parts to clean: the mouse detects the movement optically,
instead of with rubber ball mechanics.
• Gel insert for superior comfort.
nload from Www.Somanuals.com. All Manuals Search And Downl
f. Choose the "Start" menu (Ctrl & Esc) and select "Run"
g. Type [drive]:SETUP (Example D:SETUP) in the command line box
and press Enter to select OK.
h. Follow the on screen prompts to complete installation.
i. The Setup program will install the driver and add the icons
automatically.
j. When the installation is complete, the standard option is to restart
your computer.
For installation on a USB port: (Windows 98 or higher required)
a. Connect the receiver cable to the USB port
on the computer (or a USB port on a hub
connected to your computer) at any
moment. USB installation does not require
you to power off your computer.
For installation on a PS/2 mouse port: (PS/2 is not the
preferred connection method, USB offers more functionality and
control as compared to PS/2)
a. Turn off the power
to your computer
b. Attach the 6-pin connector to
the PS/2 port
c. Turn on the power to
your computer
nload from Www.Somanuals.com. All Manuals Search And Downl
INSTALLING THE BATTERIES
Whenever new batteries are inserted, make sure both are fresh AA
alkaline batteries.
5
1. Push the battery cover switch on the bottom of the mouse, and then
grasp both sides of the top cover of the mouse.
2. Pull the top cover toward the rear of the mouse.
3. Insert two AA batteries into the battery compartment, making sure
to properly orient the positive (+) and negative (-) ends as specified
by the labels in the battery compartment.
4. Reinstall the top cover and make sure it is locked.
Battery Cover Switch
Establishing Communication Between the Mouse
and Receiver
To allow the communication between the mouse and the receiver,
follow the steps below before using your cordless mouse:
Setting the Channels
The Opti Gel Cordless provides eight different ID’s for users to select.
Follow the steps below to set the channel:
LED blinks slowly
nload from Www.Somanuals.com. All Manuals Search And Downl
Channel Search Button
1. Press the Channel Search Button on the bottom of the receiver, and
note the index LED will blink slowly.
2. Press the Channel Change Button on the bottom of the mouse to set
a new channel. The index LED will blink at a faster rate when an
identical channel is located.
Channel
Change
Button
LED blinks faster
3. Press the right or left click button on the mouse to confirm the
channel matching. LED on the receiver will blink any time the
mouse sends it a signal.
FELLOWES EASY POINT SOFTWARE
6
Your Easy Point software includes features for making button
assignments, controlling cursor movements, and setting up the mouse
in Windows. To access the Easy Point software, double click the mouse
icon on the Windows Taskbar.
Mouse icon as it appears
in the Windows Taskbar
The Easy Point software can also be accessed by clicking the Start
button, point to Programs, then Fellowes followed by Easy
Point software.
nload from Www.Somanuals.com. All Manuals Search And Downl
TROUBLESHOOTING
The Fellowes Opti Gel Cordless does not work after installation or
is not detected:
7
• Check all connections to be sure they are secured to the correct
ports, and then restart the computer.
• If using as a PS/2 mouse: make sure the PS/2 mouse port has the
proper configuration. Refer to your computer documentations for
the correct port configuration. You may also have other system
devices that conflict with the mouse. Check the IRQ/address settings
of these devices for conflicts, and change the settings as required.
• If using as a PS/2 mouse: make sure that the BIOS setting on the
connect port of your computer shows Enable. Refer to your
computer document for the correct port configuration.
The screen cursor does not track well or the cursor does not move:
• The optical sensor on the mouse will not function on a highly
reflective surface such as glass, a mirror or some black surfaces.
Hence the surface of your desktop may be interfering with the
performance of the input device, utilize a traditional mouse pad or
use the mouse on a different surface.
• Orientation of the receiver: Make sure the receiver is placed as close
to the mouse as possible. Objects such as computer monitors, metal
cabinets, other 27 Mhz devices can interfere with this product. If
you can see the LED on the receiver, you should be able to see it
blink when the mouse is moved or a button is pressed. This feature
should help to determine the correct location for your environment.
• Check to make sure you are using fresh batteries.
• Change the channel ID the device is using by following the
instructions contained in this manual.
nload from Www.Somanuals.com. All Manuals Search And Downl
The cursor moves uncontrollably around the screen, files may open
and other unexplained occurances:
• There is a conflict with drivers and/or devices. Please remove all
other drivers or devices until the problem is resolved.
• Use the other port type (USB or PS/2) to resolve the conflict.
8 FELLOWES CUSTOMER SERVICE
Our technical support representatives are readily available to help you
with your problems. We will do our best to resolve the issue, or we will
offer you full support in your decision to obtain a refund (please keep
a copy of your dated sales receipt as proof of purchase). For technical
For questions about the warranty or functionality of this product, call
1-800-945-4545.
SOFTWARE LICENSE AGREEMENT
9
The enclosed software is being licensed to the original purchaser only
on the condition that all of the terms contained in this license
agreement are accepted. This is a legal agreement between the
original purchaser and Fellowes. By opening the product package the
purchaser agrees to be bound by the terms and conditions of the
agreement. If these terms are not accepted, promptly return the
software and all other items that are part of this product in their
original package with the original receipt to the point of purchase for
a full refund.
Fellowes and its suppliers offer a nonexclusive license for use of one
(1) copy of the enclosed software package ("Fellowes Easy Point
Driver") on one (1) computer only with the Fellowes mouse you have
purchased. You may make one (1) copy of the software for backup
purposes only; this copy must be labeled with all copyright and other
notices included on the software as supplied by Fellowes. Installation
onto a network server for the purpose of internal distribution of the
nload from Www.Somanuals.com. All Manuals Search And Downl
software is permitted only if each user has purchased an individual
software package for each computer to which the software is
distributed.
Fellowes Inc. and its suppliers retain ownership of all software rights.
User shall not decompile, disassemble or modify the software in any
way. User may not transfer the software using any means (except as
expressly permitted above). User may not transfer the software or
Fellowes input product except upon permanent transfer, provided user
does not retain a copy of the software, and provided transferee agrees
to be bound by the terms and conditions of this license. Upon any
violation of any of the provisions in this agreement, rights to use the
software shall terminate and all copies shall be returned to Fellowes.
FEDERAL COMMUNICATIONS
COMMISSION (FCC) NOTICE
10
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits of
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in particular installations, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
1. Reorient / Relocate the receiving antenna
2. Increase the separation between the equipment and receiver
nload from Www.Somanuals.com. All Manuals Search And Downl
3. Connect the equipment into an outlet on a circuit different from that
the receiver is connected.
4. Consult the dealer or an experienced radio / TV technician for help
CAUTION: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user’s
authority to operate the equipment.
IMPORTANT BATTERY INFORMATION:
General Precautions
• Keep batteries out of reach of children
11
• Do not mix old and new batteries or batteries of different types.
(For example rechargeable and alkaline batteries)
• Always remove old, weak, or worn-out batteries promptly and
recycle or dispose of them in accordance with your local ordinances.
• If a battery leaks, remove all batteries and recycle or dispose of
them in accordance with your local ordinances and the battery
manufacturer’s instructions. Before inserting new batteries,
thoroughly clean the battery compartment with a damp paper
towel, or follow the battery manufacturer’s recommendations for
cleanup. If fluid from the battery comes into contact with skin or
clothes, flush skin with water immediately.
• Remove the batteries if your device is to be stored for longer than
a month without being used.
Special Precautions
The precautions below are to prevent the sudden release of
electrolytes, which these prohibited actions can cause:
• Do not open, puncture, or mutilate the batteries.
• Do not heat batteries.
• Do not use fire to dispose of batteries.
nload from Www.Somanuals.com. All Manuals Search And Downl
Released battery electrolyte is corrosive, can cause damage to the
eyes and skin, and may be toxic if swallowed.
DISCLAIMER
12
The following does not apply to any country where such provisions are
inconsistent with the local law:
Fellowes Inc. makes no warranties with respect to this
documentation, whether expressed or implied. All material is
provided "as is". This includes, but is not limited to, any implied
warranties of merchantability and fitness for a particular purpose.
The information covered in this document is subject to change
without notice. Fellowes Inc. assumes no responsibility for any
errors that may appear in this document.
All brand names mentioned in this manual are trademarks or
registered trademarks of their respective companies.
Copyright 2001 Fellowes Inc. All rights reserved.
Hereby, Fellowes Inc., declares that this mouse is in compliance with
the essential requirements and other relevant provisions of Directive
1999/5/EC.
Technical documentation as required is kept at the following address:
Company: Fellowes Europe
Address: Yorkshire Way West Moor Park
Country: Doncaster, South Yorkshire
Telephone No.: 44-1302-885-331
Fax No.: 44-1302-836-999
nload from Www.Somanuals.com. All Manuals Search And Downl
LIMITED WARRANTY
13
Fellowes Inc. warrants this optical mouse to be free from defects in
material and workmanship for a period of three years from the date
of purchase by the original consumer. If any part is found to be
defective during the warrant period, your sole and exclusive remedy
will be repair or replacement, at Fellowes’ option and expense, of the
defective part.
This warranty does not apply in cases of abuse, mishandling or
unauthorized repair. ANY IMPLIED WARRANTY, INCLUDING THAT OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS
HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY
PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any
consequential or incidental damages attributable to this product. This
warranty gives you specific legal rights. You may have other legal
rights which vary from state to state.
To obtain service under this warranty on products purchased in the
USA, return the machine prepaid to the address found in the
Instruction Guide. Please allow two weeks for processing. Return with
product:
• Copy of original sales receipt.
• A card stating your name, address, daytime telephone number,
product model and serial number, plus a brief description of the
problem
For specific instructions on obtaining service under this warranty on
products purchased outside the USA, contact the appropriate office
listed on the back of the Instruction Guide.
Warrantor: Fellowes Inc.
nload from Www.Somanuals.com. All Manuals Search And Downl
1789 Norwood Avenue Itasca, Illinois 60143-1095
630-893-1600 Customer Service: 1-800-945-4545
Australia
Tullamarine, Vic.
Italy
Camerano, AN
Benelux
Vianen, NL
Japan
Tokyo
Canada
Markham, Ont.
Poland
Warsaw
France
Rennes, I-V
United Kingdom
Doncaster, S. Yorks.
Germany
Garbsen, Han.
© 2002 Fellowes Printed in China Part No. 854570
nload from Www.Somanuals.com. All Manuals Search And Downl
|