®
A USB VGA Display Port
Quick Install Guide
Supports UV 12, UV 16 and UV 19
The Following Resolutions
are Supported:
DVI connection
Resolutions may vary depending on your displays capabilities.
• 800x600, 1024x768, 1280x768, 1366x768,
1280x1024, 1440x900, 1400x1050
Supported on UV 12, UV 16, and UV 19
• 1680x1050, 1600x1200
Supported by UV 16 and UV 19 models only
• 1920x1200, 2048x1152
Supported by UV 19 model only
DVI to VGA Adapter
Hardware and Driver Setup:
1 – Power on your Laptop or your monitor and PC to begin the installation.
+
2 – Once in Windows, install the UV Plus drivers from the provided
installation CD. After the installation process has finished reboot your
computer.
+
3 – Attach your monitor’s DVI connector to UV Plus (a DVI to VGA connector
is provided if needed)
+
4 – Plug in the provided USB cable to UV Plus and the other end to your
+
Notebook or PC’s USB port. The UV Plus software will now detect your
attached display.
5 – Right-click the EVGA icon in the Windows System Tray to configure how the attached monitor should display.
+
A DVI to VGA Adapter is provided to allow a VGA connection to the UV Plus DVI connection. A USB Extension cable is
+
also provided to allow for optimum placement of your UV Plus
.
FAQ:
+
Question: Will the UV Plus attached monitor render full 3D hardware rendered graphics when in Mirror or Extended
Modes?
Answer: Yes, full 3D hardware rendered graphics can be displayed while in Mirror or Extended Modes, however running
in such a configuration is limited as the application in use may become slower or not as responsive.
+
Question: Discoloration and constant flickering occurs through the UV Plus attached monitor.
Answer: Check that your monitor’s cable is properly attached and check for loose or faulty cables. If the problem
continues, please contact EVGA Support at (888)-880-EVGA (3842)
Question: Why do I experience lag and delay when playing a 3D hardware accelerated game in either Mirrored or
Extended mode?
Answer: USB 2.0 is limited to a 480Mbps transfer speed and because of this limitation only so much data can pass
through at one time. This causes a delay that can both be seen and felt when playing a game when using the UV Plus
device.
+
+
Question: How many monitors are supported when using UV Plus
?
Answer: The maximum amount of monitors supported is 6. Note that due to current driver limitations, only a maximum
®
of 4 monitors can be used with an NVIDIA based graphics card.
+
Question: How can I stay updated with the latest UV Plus software releases?
+
Answer: The UV Plus software that installs on to your computer has a built in Auto Update feature which will
+
automatically check for any updates and then prompt you accordingly. You can right click the UV Plus icon in the
Windows System Tray and select Updates to either configure how your computer updates or to manually check for
an update.
+
Question: How do I uninstall UV Plus software?
+
Answer: In Vista/7 click Start Control Panel Uninstall a program Select EVGA UV Plus and select Uninstall.
+
In XP or 2000 click Start Settings Control Panel Add or Remove Programs Select EVGA UV Plus and select
Uninstall.
+
Question: Why does my UV Plus attached monitor not display anything when my computer is booting up or in a DOS
based environment?
+
+
Answer: UV Plus will only activate in a Windows based environment. Signal will be passed to your UV Plus attached
+
monitor when the UV Plus software has fully loaded as part of the Windows startup process.
|