Self Help Guide
Restore your Belkin VoIP unit to the factory default settings
This process may take up to 1-2 minutes
IMPORTANT!
Step 1 Open your web browser (Internet Explorer, Mozilla FireFox, Safari etc)
Before you begin
Step 2 In the Address Bar, delete any text and type in 10.1.1.1 or
You will need:
• Belkin VoIP unit
• Power cable
• Network cable
Hardware check:
• Your computer is switched on
• The VoIP unit is switched on
(power switch at rear)
• Network cable connected
from computer to the VoIP unit
Step 3 Type in your current password (default password = admin)
then click LOGIN
Step 4 On the left hand side of the screen click Advanced Setup
F1P1241EGau
Step 5 You will now be presented with more options in the menu on the left.
Click Tools then choose Configuration Tools
F1P1241ENau
Step 6 Left click on Restore router to Factory Defaults and click Next
Step 7 Click Apply, the VoIP unit will now restore to factory defaults
F1P1210ENau
and reboot.
TSG xxx004a-rev1
Page 1 of 1
If you still require further assistance
contact Belkin Technical Support
Call: 1300 554 780
|