Convection Panel Heater
2200 Watt
Instruction Booklet
HE4200
Please read these instructions carefully
and retain for future reference.
Contents
Sunbeam’s Safety Precautions
Safety precautions for your Heater
Features of your Convection Panel Heater
Using your Convection Panel Heater
To attach the feet with wheels
Troubleshooting Guide
2
3
4
6
7
8
8
Care and Cleaning
Important instructions – retain for
future use.
1
Sunbeam’s Safety Precautions
Sunbeam is very safety conscious when
designing and manufacturing consumer products,
but it is essential that the product user also
exercise care when using an electrical appliance.
Listed below are precautions which are essential
for the safe use of an electrical appliance:
• Read carefully and save all the instructions
provided with an appliance.
• Do not use an appliance for any purpose
other than its intended use.
• Do not place an appliance on or near a hot gas
flame, electric element or on a heated oven.
• Do not place on top of any other appliance.
• Do not let the power cord of an appliance hang
over the edge of a table or bench top or touch
any hot surface.
• Always turn the power off at the power outlet
before you insert or remove a plug. Remove
by grasping the plug - do not pull on the cord.
• Turn the power off and remove the plug
when the appliance is not in use and
before cleaning.
• Do not use your appliance with an extension
cord unless this cord has been checked
and tested by a qualified technician or
service person.
• Always use your appliance from a power
outlet of the voltage (A.C. only) marked
on the appliance.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
• Do not operate any electrical appliance with
a damaged cord or after the appliance has
been damaged in any manner. If damage is
suspected, return the appliance to the nearest
Sunbeam Appointed Service Centre
for examination, repair or adjustment.
• For additional protection, Sunbeam
recommend the use of a residual current
device (RCD) with a tripping current not
exceeding 30mA in the electrical circuit
supplying power to your appliances.
• Do not immerse the appliance in water
or any other liquid unless recommended.
• Appliances are not intended to be operated
by means of an external timer or separate
remote control system.
• This appliance is intended to be used in
household and similar applications such
as: staff kitchen areas in shops, offices and
other working environments; farm houses; by
clients in hotels, motels and other residential
type environments; bed and breakfast type
environments.
• Children should be supervised to ensure that
they do not play with the appliance.
• The temperature of accessible surfaces may be
high when the appliance is operating.
If you have any concerns regarding the performance and use of your appliance,
Ensure the above safety precautions are understood.
2
Safety Precautions For Your Heater
SAFETY PRECAUTIONS FOR YOUR
• Do not locate the heater immediately below a
SUNBEAM CONvECTION PANEL hEATER.
socket outlet.
• This heater becomes hot during use. To avoid
burns, do not let bare skin touch hot surfaces.
If provided, use handles when moving this
heater. Keep combustible materials such as
furniture, pillows, bedding, papers, clothes and
curtains at least 1metre away from the front of
the heater and keep them away from the sides
and rear.
• Do not use this heater in the immediate
surroundings of a bath, shower, laundry area or
swimming pool.
• Do not insert or allow foreign objects to enter
any ventilation or exhaust openings as this may
cause electric shock or fire and damage to the
heater.
• To prevent possible fire, do not block air
intakes or exhaust in any manner. Do not use
on soft surfaces, such as beds, where opening
may become blocked.
• Extreme caution is necessary when any heater
is used by or near children or invalids and
whenever the heater is left unattended.
• To prevent overheating, do not cover the heater.
• Always unplug the heater when not in use.
• Do not use outdoors.
• A heater has hot and arcing or sparking parts
inside. Do not use it in areas where petrol,
paint or flammable liquids are used or stored.
• If the appliance overheats, for example due to
the air inlet or outlet grilles being accidentally
blocked. The element automatically
de-energizes until the heater cools down.
As an added precaution we recommend
unplugging the heater.
• Do not run the cord of the heater under
carpeting. Do not cover the cord with throw
rugs, runners or other floor coverings. Arrange
the cord away from traffic areas to avoid a
tripping hazard.
3
Features of your Sunbeam
Convection Panel Heater
Slimline Design
Pressed metal exterior
Solid stable feet
Wheels for easy maneuverability
4
Thermostat controlled operation
2 Heat and off setting
Thermostat indicator light
5
Using your Sunbeam Convection
Panel Heater
1.Place the heater on a flat level surface.
Ensure that the heater is at least 1 metre
away from furniture and curtains.
6.Before storing your heater we recommend
allowing the heater to cool down.
NOTE: Before first use we recommend
switching your heater on in a well ventilated
area to disperse any vapours that have
resulted during the production of this heater.
Once cleared, this will not reoccur.
2.Insert the plug into a 230-240 power outlet.
Turn the power on.
3.Press the switch to either LOW or hIGh
setting.
4.To achieve your desired room temperature
use the Thermostat Control dial which
adjusts the temperature.
5.To turn off your heater, switch your heat
setting button to the 0 position.
6
To attach the feet with wheels
The hE4200 has the feet with wheels and screws stored within the box, separate to the body.
Mounting
Locating
Screw
holes
slots
Positioning is only possible in the one orientation, either foot can be used at either end.
Attaching the feet with wheels
1.Carefully position the heater upside down on a carpeted area.
2.Use the screws provided to fix the feet with wheels to the body at either end of the heater
using a screwdriver.
7
Troubleshooting Guide
1.If your heater fails to operate, check the
following:
- Check that the thermostat is not set too low.
Turn the dial clockwise to adjust the electric
thermostat. Until the heater restarts.
- Make sure the electrical outlet or circuit
breaker is working..
- Check for obstructions, if obstructions are
present, the heater may have gone over
temperature. If this is the case turn off
the heater at the power outlet, remove the
obstructions and wait for the heater to cool
before turning the heater back on.
Care and Cleaning
Ensure that the heater is switched off and
disconnected from the power outlet before
cleaning.
Do not use harsh or abrasive cleaners to
clean your heater, as these will damage the
surface.
Carefully wipe the exterior of the heater with
a soft damp cloth and dry thoroughly with a
dry cloth.
When not in use store the heater in a cool
dry place.
Over time, dust may accumulate on the front
grille. This can be removed by wiping with a
damp cloth, or by carefully going across the
grille with a vacuum cleaner or hand held
vacuum.
8
2 Year Replacement Guarantee
In the unlikely event that this appliance develops any malfunction
within 2 years of purchase (3 months commercial use) due to
faulty materials or manufacture, we will replace it for you
free of charge.
Should you experience any difficulties with
your appliance, please phone our customer
service line for advice on 1300 881 861 in
Australia, or 0800 786 232 in New Zealand.
Alternatively, you can send a written claim
to Sunbeam at the address listed below.
On receipt of your claim, Sunbeam will
seek to resolve your difficulties or, if the
appliance is defective, advise you on how
to obtain a replacement or refund.
In Australia you are entitled to a
replacement or refund for a major failure and
for compensation for any other reasonably
foreseeable loss or damage. You are also
entitled to have the goods repaired or
replaced if the goods fail to be of acceptable
quality and the failure does not amount to
a major failure.
Should your appliance require repair or
service after the guarantee period, contact
your nearest Sunbeam service centre.
Your Sunbeam 2 Year Replacement
Guarantee naturally does not cover misuse
or negligent handling and normal wear and
tear.
For a complete list of Sunbeam’s authorised
service centres visit our website or call:
Australia
Similarly your 2 Year Replacement Guarantee
does not cover freight or any other costs
incurred in making a claim. Please retain
your receipt as proof of purchase.
1300 881 861
Units 5 & 6, 13 Lord Street
Botany NSW 2019 Australia
The benefits given to you by this guarantee
are in addition to your other rights and
remedies under any laws which relate to the
appliance.
New Zealand
0800 786 232
26 Vestey Drive, Mt Wellington
Auckland, New Zealand
Our goods come with guarantees that cannot
be excluded under the Australian Consumer
Law and under the New Zealand Consumer
Guarantees Act.
Need help with your appliance?
Contact our customer service team or visit
our website for information and tips on
getting the most from your appliance.
In Australia
Or call 1300 881 861
In New Zealand
Or call 0800 786 232
is a registered trademark.
Made in China.
Due to minor changes in design or otherwise,
the product may differ from the one shown in this leaflet.
© Copyright. Sunbeam Corporation Limited 2011.
ABN 45 000 006 771
Units 5 & 6, 13 Lord Street
Botany NSW 2019 Australia
Unit 3, Building D
26 Vestey Drive
Mt Wellington Auckland
New Zealand
Sunbeam Corporation is a division of GUD Holdings Ltd.
11/11
|