English
Power handling capacity
Maximum input power: 200 watts
Connections
Sensitivity level
Frequency range
90 dB (1 W, 1 m )
35 Hz - 50,000 Hz
• Before connecting, turn off the amplifier or receiver to
avoid damaging the speaker system.
Speaker System
• This speaker system is driven best by an amplifier or
receiver rated as per the wattage indicated in the
specification section.
A low-powered amplifier or receiver could result in
signal clipping, which could result in tweeter burn-out.
Therefore, it is recommended to use an amplifier or
receiver with sufficient power rating.
Dimensions (w/h/d) Approx. 290 × 1,065 × 303 mm
(11 1/2 × 42 × 12 in.) including front
grille
SS-F7000/F6000/F5000
Mass
Supplied accessory
Approx. 15 kg (33 lb 2 oz)
Speaker cord (2)
2-899-179-11(1)
SS-F6000
Note
Speaker system
Speaker units
4-way, magnetically shielded
Woofer (Mid Bass): 16 cm (6 3/8 in.),
cone type
Avoid driving the speaker system continuously with a
wattage exceeding the maximum input power of each
speaker.
(1)
Woofer (Mid Low): 16 cm (6 3/8 in.),
cone type
Owner’s Record
Precautions
Midrange: 8 cm (3 1/4 in.), cone type
Tweeter: 2.5 cm (1 in.), balanced dome
type
The model and serial numbers are located on the rear of the unit. Record the
serial number in the space provided below. Refer to them whenever you call
upon your Sony dealer regarding this product.
• Do not attempt to open the enclosure or remove
speaker units. There are no user-serviceable parts
inside.
Enclosure type
Bass reflex
• Keep recorded tapes, watches, and personal credit
cards using magnetic coding away from the speaker
system.
Rated impedance
Power handling capacity
Maximum input power: 180 watts
Sensitivity level
Frequency range
Dimensions (w/h/d) Approx. 215 × 950 × 260.5 mm
(8 1/2 × 37 1/2 × 10 3/8 in.) including
front grille
8 ohms
Model No.
Serial No.
•
Periodically wipe the cabinet with a soft cloth. Do not
use any type of scouring powder, abrasive pad or
solvent.
89 dB (1 W, 1 m )
40 Hz - 50,000 Hz
Standard Connection
• Be sure to install the grill net in the correct direction.
Right
Left
Speaker Placement
Please note that room acoustics can often produce large
difference in the sound for small changes in speaker
placement.
Mass
Supplied accessory
Approx. 12.2 kg (26 lb 15 oz)
Speaker cord (2)
• Set your speaker system on a floor which is hard, flat
place.
SS-F5000
Speaker system
Speaker units
3-way, magnetically shielded
Woofer: 20 cm (8 in.), cone type
Midrange: 8 cm (3 1/4 in.), cone type
Tweeter: 2.5 cm (1 in.), balanced dome
type
• Place the speaker system against a hard wall with its
back about 10 cm (4 in.) away from a wall. The
proportion of bass increases as you move a speaker
close to intersecting room surfaces (wall and wall, etc.).
• Place the right and left speakers in a similar acoustic
environment.
+
–
Enclosure type
Rated impedance
Power handling capacity
Maximum input power: 150 watts
Bass reflex
8 ohms
• It is recommended that the speaker/listener
relationship be an equilateral triangle.
Specifications
Sensitivity level
Frequency range
Dimensions (w/h/d) Approx. 240 × 850 × 263 mm
(9 1/2 × 33 1/2 × 10 3/8 in.) including
front grille
88 dB (1 W, 1 m )
45 Hz - 50,000 Hz
Amplifier
SS-F7000
SPEAKER
Speaker system
Speaker units
4-way, magnetically shielded
Woofer (Mid Bass): 20 cm (8 in.),
cone type
Mass
Supplied accessory
Approx. 11.3 kg (24 lb 15 oz)
Speaker cord (2)
Woofer (Low Bass): 20 cm (8 in.),
cone type
Midrange: 8 cm (3 1/4 in.), cone type
Tweeter: 2.5 cm (1 in.), balanced dome
type
Design and specifications are subject to change without
notice.
Enclosure type
Bass reflex
2007 Sony Corporation Printed in Malaysia
Rated impedance
8 ohms
|