again to end.
4-180-210-12(1)
Hold down for about two seconds to
reject an incoming call.
When you let go, two low beeps
confirm the call was rejected.
Volume –
On copyright
iPhone , iPod , iPod classic , iPod
® ®
®
nano , iPod shuffle , and iPod
®
®
touch are trademarks of Apple Inc.,
Operating Instructions
Manual de instrucciones
®
registered in the U.S. and other
Decreases the volume of the connected
iPod product.
Microphone
countries. iPad is a trademark of
Stereo
®
Apple Inc.
Headset
“Made for iPod,” “Made for iPhone,”
and “Made for iPad” mean that an
electronic accessory has been designed
to connect specifically to iPod, iPhone,
or iPad, respectively, and has been
certified by the developer to meet
Apple performance standards. Apple is
not responsible for the operation of
this device or its compliance with
safety and regulatory standards.
* Availability of the “VoiceOver” feature
depends on iPod and its software version.
DR-E10iP
Specifications
Receiver
Type:
Open air, dynamic
Driver unit:
13.5 mm, dome type
(CCAW)
Power handling capacity:
100 mW (IEC*)
Impedance:
©2010 Sony Corporation Printed in Thailand
Features
Easy-to-use remote control (only for
iPod, iPhone and iPad).
In-line microphone for hands-free
phone calls of iPhone.
16 Ω at 1 kHz
Sensitivity:
English
Stereo headset
104 dB/mW
Frequency response:
18 – 22,000 Hz
Earbud style headset in fashionable
colors.
Neodymium magnet delivers
powerful sound.
Cord:
1.2 m (47 1/4 in), Litz cord
WARNING
Y-type
Plug:
Four-conductor gold-plated
stereo mini plug for iPod
with remote function
Approx. 6 g (0.21 oz)
without cord
To reduce the risk of fire or electric
shock, do not expose this
apparatus to rain or moisture.
How to use
Wearing the headphones
Mass:
To reduce the risk of electrical
shock, do not open the cabinet.
Refer servicing to qualified
personnel only.
Microphone
(see fig. )
Open circuit voltage level:
– 42 dB ( 0 dB=1 V/Pa)
Wear the earpiece marked in your
right ear and the one marked in
your left ear.
Supplied accessories
Earpads (2)
You are cautioned that any changes or
modifications not expressly approved
in this manual could void your
If the headphones do not fit your ears,
put on the supplied earpads.
(See fig. )
Card warranty (1)
Operating Instructions (1)
authority to operate this equipment.
* IEC = International Electrotechnical
Commission
Design and specifications are subject
to change without notice.
How to use the cord slider
(see fig. -)
Move up and down to change the split
position of the cord.
Compatible iPod/
iPhone models
You can use the unit with only the
following models supporting remote
control. Update your iPod, iPhone or
iPad to the latest software before use.
In the Operating Instructions, iPod,
iPhone and iPad are collectively
described as “iPod” except in special
cases.
Precautions
How to use the remote
and microphone for an
iPod (see fig. -)
You can control a connected iPod
product.
Listening with headphones at high
volume may affect your hearing. For
traffic safety, do not use while
driving or cycling.
Be careful not to allow any buttons
to be unintentionally pressed when
the headphones with iPod connected
are in a carrying pouch, etc.
iPod touch 4th generation
iPod touch 3rd generation
iPod touch 2nd generation
iPod nano 6th generation
iPod nano 5th generation
iPod nano 4th generation
iPod classic 120GB 160GB (2009)
iPod shuffle 4th generation
iPod shuffle 3rd generation
iPhone 4
Parts and controls
Volume +
Increases the volume of the connected
iPod product.
Note on static electricity
In particularly dry air conditions, mild
tingling may be felt on your ears. This
is a result of static electricity
accumulated in the body, and not a
malfunction of the headphones.
The effect can be minimized by
wearing clothes made from natural
materials.
Center button
Plays/pauses a track of the connected
iPod product with a single press. Skips
to the next track with a double press.
Skips to the previous track with a triple
press. Starts the “VoiceOver*” feature
with a long press (if available).
Press once to answer the call. Press
iPhone 3GS
iPad
|