Samson Speaker VX410 User Guide

VX410  
VX410a  
series  
VX115 BASS  
4 x10+ 1High Frequency CD  
Bass Enclosure  
Hartke  
 
Connecting the VX410 and VX410a  
About Impedance  
Before you hook up your speaker cabinet be sure that you understand a little about  
impedance. Impedance is the electronic load that the speaker puts on the power amplifier  
and is measured in Ohms.  
Here is the tricky, yet simple rule of impedance; When two speakers are wired in "Parallel"  
EFFECT  
the total impedance is cut in half and  
Hartke Systems  
Distributed Exclusively by  
Samson Technologies Corp.  
Hicksville, New York 11802  
RETUIRN  
SEND  
MODEL 2000  
200 WATTS  
~
AC INPUT  
115V/230V 50/60Hz  
FUSE  
5A/250V, 180W (115V)  
2.5A/250V, 450W (230V)  
when two speakers are wire is “Series”  
the total impedance is the sum of the  
speakers individual impedance.  
8
4
=
=
120 WATTS  
200 WATTS  
SPEAKER OUTPUTS  
CAUTION  
TO PREVENT SHOCK, DO NOT OPEN. NO USER SERVICE-  
ABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED  
SERVICE PERSONNEL. TO PREVENT FIRE OR SHOCK  
HAZARD, DO NOT EXPOSE TO RAIN OR MOISTURE.  
HPF  
OFF  
ON  
8
8
SERIAL NUMBER  
ASSEMBLED IN R.O.K.  
The VX410 and VX410a’s impedance  
(many audio guys used the made up  
word “ohmage”, however the correct  
term is impedance) is 8 Ohms. So,  
when two VX410’sor VX410a’s are con-  
nected together in parallel the total  
impedance is 4 Ohms. The impedance  
of your speaker also has an effect on  
you amplifier. In general, the lower the  
impedance the more power your ampli-  
fier will put out.  
Hartke  
-series  
VX410 BASS CABINET  
400 WATTS  
Hartke Systems Distributed worldwide by Samson echnologies  
T
INPUTS  
8
EXTENSION  
MADE IN CHINA  
SERIAL NUMBER  
IMPORTANT: There is an minimum safe  
impedance so be sure to check the  
manufacturer’s recommended imped-  
ance for your amplifier to avoid any  
damage to your amplifier or voiding  
your warranty.  
EFFECT  
Hartke Systems  
Distributed Exclusively by  
Samson Technologies Corp.  
Hicksville, New York 11802  
RETUIRN  
SEND  
MODEL 2000  
200 WATTS  
~
AC INPUT  
115V/230V 50/60Hz  
FUSE  
5A/250V, 180W (115V)  
2.5A/250V, 450W (230V)  
8
4
=
=
120 WATTS  
200 WATTS  
SPEAKER OUTPUTS  
CAUTION  
TO PREVENT SHOCK, DO NOT OPEN. NO USER SERVICE-  
ABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED  
SERVICE PERSONNEL. TO PREVENT FIRE OR SHOCK  
HAZARD, DO NOT EXPOSE TO RAIN OR MOISTURE.  
HPF  
OFF  
ON  
8
8
SERIAL NUMBER  
ASSEMBLED IN R.O.K.  
Connecting the VX410 to Your Amplifier  
The VX410 and VX410a connections  
are made via 1/4” phone jacks located  
on the rear panel jack-plate. Be sure to  
make your connection with un-shielded  
speaker cable. Connect the Amplifier  
Output to the speaker Input on the  
VX410’s rear jackplate.  
Hartke  
-series  
VX410 BASS CABINET  
400 WATTS  
Hartke Systems Distributed worldwide by Samson echnologies  
T
INPUTS  
8
EXTENSION  
MADE IN CHINA  
SERIAL NUMBER  
Using the EXTENSION Output  
The VX410and VX410a provides a  
convenient Extension Output for con-  
necting additional speaker cabinets in  
parallel. Be sure to read the section  
above on impedance to insure a proper  
hook up with your amplifier. Follow the  
steps below to connect two VX410’s  
using the Extension Output. Connect  
the Amplifier Output to the Input of the  
first VX410. Now, connect the  
Hartke  
-series  
Extension Output to the Input of the  
second VX410 or VX410a.  
VX410 BASS CABINET  
400 WATTS  
Hartke Systems Distributed worldwide by Samson echnologies  
T
INPUTS  
8
EXTENSION  
MADE IN CHINA  
SERIAL NUMBER  
 
VX410 and VX410a Specifications  
Type  
Bass speaker enclosure  
Impedance (Ohms)  
Power Handling  
8 Ohms Impedance  
400 Watts Peak Power Handling  
Low Frequency Drivers  
High Frequency Driver  
Dimensions  
4-10Special Design 8 ohm, 100  
wattSpeakers,  
1Throat Compression Driver  
Height:25(62.2 cm)  
Width: 25(62.2 cm)  
Depth: 15(47.0 cm)  
Weight  
VX410  
VX410a  
72 lbs. (32.6 kg)  
70 lbs. (31.68 kg)  
Specifications subject to change without notice.  
Hartke  
Distributed Worldwide Exclusively by:  
Samson Technologies Corp.  
575 Underhill Blvd.  
P.O. Box 9031  
Syosset, NY 11791-9031  
Phone: 1-800-3-SAMSON (1-800-372-6766)  
Fax: 516-364-3888  
 

Radio Shack Video Game Keyboard MD 1210 User Guide
Ricoh Fax Machine Facsimile User Guide
RIDGID Sander R2611 User Guide
Royal Sovereign Air Conditioner ARP 1400BLS User Guide
Ryobi Automobile Parts AC04150T User Guide
Samsung DVD Player AH68 02252K User Guide
Samsung Webcam VC240 User Guide
Sanyo Heat Pump APR P680BA User Guide
Savin Printer RCP40 User Guide
Sears Automobile Electronics 13953876 User Guide