®
juice extractor
Instruction Booklet
Model: JE-1187
21. Do not put your fingers or other objects into the feed tube while it is
operating. Always use the food pusher provided. If food becomes lodged
in the feed tube use the food pusher or another piece of fruit or vegetable
with the food pusher to push it down. If this is not possible, turn the motor
off and unplug the unit from the wall outlet and disassemble the unit
to remove the stuck food.
22. Do not place on or near a hot gas or electric burner, or in a heated oven.
23. Always attach plug to appliance first, then plug cord into the wall outlet. To
disconnect, turn any control to ‘OFF’, then remove plug from wall outlet.
SAVE THESE INSTRUCTIONS
HOUSEHOLD USE ONLY
POLARIZED PLUG
This appliance has a polarized plug (one blade is wider than the other). To
reduce the risk of electric shock, this plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician. Do not modify the plug in any way.
BEFORE FIRST USE
1. Read the instructions carefully and keep for future reference
2. Remove all packaging.
3. Disassemble the juicer (see the Care and Cleaning section). Wash all
removable parts to remove any residue left over from the manufacturing
process.
3
DESCRIPTION OF PARTS
1. Motor Housing
2. Rocker Switch
A - Lo speed
B - Off
C - Hi speed
3. Locking Handle
4. Juice Collector
5. Spout
6. Stainless Steel Strainer Basket/Cutting Blades
7. Feed Tube
8. Pulp Chute/Juicer Cover
9. 2.2 litre/quart Pulp Container
10. Food Pusher
11. Froth Separator
12. 1.2 litre/quart Juice Jug
6
7
10
11
4
8
5
3
9
1
2A
2B
2C
•LO
•OFF
•HI
12
HOW TO ASSEMBLE THE JUICER
1. Place the Juice Collector on the Motor Housing with the Spout facing the
direction of the Locking Handle. Gently slide into place until it locks.
2. Place the Stainless Steel Strainer Basket inside the Juice Collector. Twist
the Strainer Basket and gently push down until it is seated in the Juice
Collector. NOTE: The top edge of the Strainer Basket should not be
higher than the edge of the Juice Collector when properly installed.
3. Place the Pulp Chute/Juicer Cover on the top so that the opening of the
Pulp Chute is on the side opposite the Spout.
4. Lock the Pulp Chute/Juicer Cover into position by raising the Locking Bar
until it clicks into the grooves located on both side of the Pulp
Chute/Juicer Cover. NOTE: Push the Locking Bar until it is fully upright
otherwise the Juicer will not operate.
5. Align the groove in the Food Pusher with the small protrusion on the
inside of the Feed Tube.
6. Slide the Pulp Container into position under the Pulp Chute.
7. If the Froth Separator is not in the Juice Jug, slide between the tabs
inside the Juice Jug. If you prefer to have juice with froth then the Froth
Separator is not required
HOW TO PREPARE FRUIT AND VEGETABLES FOR JUICING
1. Wash fruits and vegetables.
2. Peel fruits that have inedible skins such as citrus fruits, pineapple,
melons, papaya, etc.
3. Pit all fruits with hard seeds or stones such as peaches, nectarines,
cherries, etc.
4. Most fruits and vegetables such as apples, carrots and cucumbers will not
need to be cut. If the pieces are too big for the Feed Tube slice the fruit
or vegetables before starting to juice.
5
HOW TO JUICE
1. Assemble the Juicer. The Juice Jug or a glass can be placed below the
spout to collect juice.
2. Plug the power cord into a 120V power outlet.
3. Choose either ‘Hi’ or ‘Lo’ speed on the Rocker Switch depending on the
type of fruit or vegetable that is being juiced. Never put any fruit or
vegetables in the juicer until power is turned on. Soft fruit or vegetables,
such as berries, melons, cucumber, tomatoes, etc. should be juiced on Lo
speed. Harder fruit and vegetables such as apples, celery, carrots, etc.
should be juiced at ‘Hi’ speed.
4. With the motor running, place food into the Feed Tube. Using the Food
Pusher, gently guide food down the Feed Tube. To Extract the maximum
amount of juice, always push the Food Pusher down slowly. IMPORTANT:
DO NOT PLACE HANDS OR FOREIGN OBJECTS DOWN THE FEED
TUBE. ALWAYS USE THE FOOD PUSHER
5. If the Pulp Container is full it can be emptied during juicing. Turn the
Juicer Off and remove the Pulp Container by holding onto the Feed Tube
and tilting the juicer slightly to disengage the Pulp Container. Empty the
Pulp Container. Replace by sliding the Pulp Container into position under
the Pulp Chute.
6. The froth separator in the Juice Jug will eliminate froth being poured into
the glass. If you prefer to have juice with froth, simply remove the froth
separator attachment from the Juice Jug before juicing.
IMPORTANT: When juicing on ‘Hi’ Speed do not run the juicer for
longer than 5 minutes then allow to rest for 2 minutes before you
resume juicing.
6
HELPFUL HINTS
•
•
•
A small amount of lemon juice can be added to apple juice to prevent
browning.
Do not use bananas or avocados as they do not contain juice and will
clog the juicer.
Allow the juicer to run for one minute before turning ‘Off’ to allow any
excess juice to be extracted from the pulp.
•
•
A plastic bag can be put in the pulp container for easy clean-up.
Disassemble the Juicer and rinse off the pulp immediately after juicing.
The Strainer Basket/Cutting Blades can be soaked in water to loosen the
pulp. Then wash in warm soapy water.
•
•
Wash parts immediately after use to avoid discolouration of the plastic
parts which may occur with some fruits and vegetables.
If juicing herbs or leafy green vegetables process in combination with
other fruits or vegetables to yield more juice.
CARE AND CLEANING
How to Disassemble the Juicer
IMPORTANT: Before disassembling the juicer make sure that the Rocker
Switch is in the Off position, the plug has been removed from the wall outlet
and the motor has stopped completely.
1. Remove the Food Pusher from the Feed Tube.
2. Remove the Pulp Container by holding onto the Feed Tube and tilting the
juicer slightly to disengage.
3. Remove the Juice Jug.
4. Hold the Pulp Chute/Juicer Cover and disengage the Locking Bar from the
grooves on the side of the Pulp Chute/Juicer Cover.
5. Lift and remove the Pulp Chute/Juicer Cover.
6. Remove the Strainer Basket by gently sliding your fingers around the rim
of the Basket and lifting upwards. NOTE: Be careful when handling the
Strainer Basket as the cutting blades are very sharp.
7. Remove the Juice Collector by placing one hand under the plastic edge
opposite the spout and lifting upwards, then gently slide out.
7
How to Clean
1. Move the Rocker Switch to the Off position and wait for the motor to stop
completely.
2. Unplug from the wall outlet.
3. Disassemble the Juicer (see directions above)
4. Clean the Pulp Container, Pulp Chute/Juicer Cover, Food Pusher, Juice
Collector, Juice Jug and Froth Separator in warm, soapy water. A mild
detergent is recommended. Rinse well and dry thoroughly.
5. Hold the Stainless Steel Strainer Basket/Cutting Blades under clean running
water. If needed, use a small brush to gently clean away pulp from the
filter and cutting blades. Rinse under running water. Hold the Strainer
Basket/Cutting Blades up to the light to ensure that the fine mesh holes are
not blocked. If the holes are blocked, soak the Strainer Basket/Cutting
Blades in hot water to loosen the pulp and clean with the brush again.
Allow to dry on a cloth or paper towel before reassembling the juicer.
CAUTION: THE CUTTING BLADES ARE VERY SHARP.
6. Wipe the Motor Housing with a soft cloth moistened in warm soapy water.
NEVER IMMERSE MOTOR HOUSING IN WATER OR ANY OTHER LIQUID.
TROUBLESHOOTING
PROBLEM
SOLUTION
The safety locking arm may not be correctly
engaged into the 2 grooves on either side of the
Pulp Chute/Juicer Cover.
Juicer will not operate when
switched on.
Push the Food Pusher down slowly so that wet pulp
does not build up under the Pulp Chute/Juicer
Cover. Choose Hi speed instead of Lo speed.
Motor stalls when juicing
Excess pulp building up in filter
Pulp too wet
Alternate soft and hard fruit and vegetables
Use Lo speed. Check to be sure that the holes in
the mesh filter are not blocked. If they are blocked
follow #5 in the How to Clean section.
Juice leaks between the rim of the Use Lo speed. Fruits and vegetables with a high
Juicer and Pulp Chute/Juicer Cover water content should be juiced on Lo speed.
8
RECIPES
Below are a few juice recipes for your convenience. Additional recipes are a
vailable on the internet. Recipe books are also available at your local bookstore.
Apple Strawberry
5 apples
1 cup strawberries
Alternate juicing apples and strawberries. Serve immediately.
Apple Veggie Juice
2 apples
3 carrots
1 stalk celery
Alternate juicing apples, carrots and celery. Serve immediately.
Vegetable Juice
4 carrots
2 ozs. (100 g) spinach
Small handful of flat leaf parsley
2 stalks celery
Alternate juicing above ingredients. Serve immediately.
Fruit & Vegetable Cocktail
1/2 pineapple, peeled
1 carrot
1 apple
1 stalk celery
Process through juicer and serve immediately.
Peach, Pear and Apple Juice
1 apple
2 peaches, seed removed
1 pear
Process ingredients through juicer and serve immediately.
9
A short supply cord is provided to reduce the hazards of becoming entangled
in or tripping over a long cord. Extension cords may be used if care is exer-
cised in their use. If an extension cord is used, the marked electrical rating of
the detachable power-supply cord or extension cord should be at least as great
as the electrical rating of the appliance. If the appliance is of the grounded
type, the extension cord should be a grounded 3-wire cord. The extension cord
should be arranged so that it will not drape over the counter top or table top,
where it can be pulled on by children or tripped over.
LIMITED WARRANTY
Salton Canada warrants that this appliance shall be free from defects in material and
workmanship for a period of one year from the date of purchase. During this
‘in-warranty’ period, defective products will be repaired or replaced at the discretion
of the retailer and/or Salton Canada. This warranty covers normal domestic usage
and does not cover damage which occurs in shipment or failure which results from
alteration, accident, misuse, abuse, glass breakage, neglect, commercial use or
improper maintenance.
A defective product should be returned to the original place of purchase within the
retailer’s stipulated return/exchange period*. If you are unable to have a defective
product replaced under warranty by the retailer, please check our website at
assistance by mail, e-mail, fax or telephone as listed below.
To ensure prompt ‘in-warranty’ service securely package and return the product to us
prepaid. Be sure to include the original proof of purchase and a description of the
defect along with your address and postal code.
For repairs not covered by the warranty, please contact us for assistance.
®
SALTON CANADA
Customer Service Department
81A Brunswick,
Dollard-des-Ormeaux,
Quebec, Canada H9B 2J5
E-mail: [email protected]
Fax: 514-685-8300
Tel: 514-685-3660 Ext. 226
* Return/exchange policies at each retailer vary and may differ from the SALTON Canada 1 year limited
warranty period.
10
|