R
RUB
TECH
Gigabit Switch
Networking & Communications
L2 Plus Managed Switch
FGS-2924R
FGS-2924R:
16-Port SFP + 8-Port Combo GbE L2 Plus Managed Switch
Benefits
QoS with four priority queues
Key Features
24-Port Gigabit SFP High Port Count
Fiber Switch
The QoS(Quality Of Service) Control List (QCL) feature provides four
internal queues to support four different classifications of traffic. High
priority packet streams experience less delay inside the switch, which
supports lower latency for certain delay-sensitive traffic. The
FGS-2924R can classify the packet as one of the four priorities
according to vip port, 802.1p priority tag, DiffServ and/or IP TOS, IPv4
and UDP/TCP application traffics. The QoS operate at full wire speed.
The actual scheduling at each egress port can be based upon a strict
priority, weighted round robin or a mix of both.
9KB Jumbo Frame Support
IEEE 802.1x Access Control Improve
Network Security
Port Mirroring Helps Supervisor
Monitoring Network
Q-in-Q VLAN for performance & security
and 4094 Vlan entries(prevision,
upgrade via FW)
Port Mirroring
IEEE 802.1D Compatible, 802.1w Rapid
Spanning Tree and 802.1s Multiple
Spanning Tree
It is based on ACLfunction to classify the ingress traffic to do port copy.
This mechanism helps track network errors or abnormal packet
transmission without interrupting the flow of data. Allow ingress traffic
to be monitored by a single port that is defined as mirror capture port.
The mirror capture port can be any 10/100 port, 10/100/1000 port.
Mirroring multiple ports is possible but can create congestion at the
mirror capture port.
Unknown Unicast/Broadcast/Multicast
Storm Control
Multicast Vlan Management for IPTV
IP-Mac-Port binding for LAN security
QCL Based on Application traffic for QoS
and rate limitation management
ACL Based on Ethernet Type / ARP /
IPv4 for packets permit or deny, rate
limitation and port copy
Q-in-Q VLAN for performance & security
(prevision, upgrade viaFW)
The VLAN feature in the switch offers the benefits of both security and
performance. VLAN is used to isolate traffic between different users
and thus provides better security. Limiting the broadcast traffic to within
the same VLAN broadcast domain also enhances performance. Q-in-Q,
the use ofdouble VLAN tags is an efficient method for enabling
Subscriber Aggregation. This is very useful in the MAN.
DHCP Option 82 relay agent
Overview
FGS-2924R, a 24-port Gigabit L2 Plus
Managed Switch, is a standard switch that
meets all IEEE 802.3/u/x/z Gigabit, Fast
Ethernet specifications. The switch
Isolated Group, provides protection for certain ports
The isolated group feature allows certain ports to be designated as
protected. All other ports are non-isolated. Trafficbetween isolated
group members is blocked. Traffic can only be sent from isolated group
to non-isolated group.
includes 16-Port 1000Mbps SFP and
8-Port Combo Gigabit TP/SFP Fiber dual
media management Ethernet switch. The
switch can be managed through RS-232
serial port, or through Ethernet port using
CLI or Web-based management unit,
associated with SNMP agent. With the
SNMP agent, the network administrator
can logon the switch to monitor, configure
and control each port's activity in a friendly
way. The overall network management is
enhanced and the network efficiency is
also improved to accommodate high
bandwidth applications. In addition, the
switch features comprehensive and useful
functions such as QoS (Quality of Service),
Mac-based 802.3ad LACP with automatic link fail-over
Dynamic fail-over means packets will not get assigned to any trunk
member port that has failed. If one of the ports were to fail, traffic will
automatically get distributed to the remaining active ports.
802.1x Access Control improves network security
802.1x features enable user authentication for each network access
attempt. Port security features allow you to limit the number of MAC
addresses per port in order to control the number of stations for each
port. Static MAC addresses can be defined for each port to ensure only
registered machines are allowed to access. By enabling both of these
features, you can establish an access mechanism based on user and
machine identities, as well as control the number of access stations.
802.1d Compatible & 802.1w Rapid Spanning Tree
For mission criticalenvironments with multipleswitches supporting
R
RUB
TECH
Gigabit Switch
Networking & Communications
L2 Plus Managed Switch
---Flooding unknown vlan frame setting, can flood packet with some
vlan tag associated to a invalid/inactive vlan
---In tag-base VLAN, supports egress/ingress packet filter
---Q-in-Q is an efficient method for enabling Subscriber Aggregation
---Provide Management Vlan for managed policy
QoS
---Supports QCL for Layer 4 TCP/UDP Port and ToS Classification
---Supports 802.1p QoS with four level priority queue
---Supports priority in a Q-in-Q tag
Bandwidth Control
---Supports bandwidth rating per port ingress and egress rate limit 500Kbps~1000Mbps with 1Kbps
Protocol
LACP
---Port trunking with 12 trunking group
---Up to 16 ports for each group.
GVRP/GARP
---802.1q with GVRP/ GARP
Multicasting
---Supports IGMP snooping including active and passive mode
STP/RSTP/MSTP
---802.1d/1w/1s
Network Security
---802.1x access control for port based and mac based authentication
---Management Access Policy Control
---Access control List
---IP-mac-port binding
---DHCP relay agent
Snmpv1,v2c Network Management
RFC 1213 MIB (MIB-II)
---Interface MIB
---Address Translation MIB
---IP MIB
RFC 1757 RMON MIB
---StatisticsGroup 1
---History Group 2
---Alarm Group 3
---ICMP MIB
---Event Group 9
---TCP MIB
RFC 1493 Bridge MIB
RFC 1643 Ethernet MIB
Enterprise MIB
---UDP MIB
---SNMP MIB
LED Description
LED
Global
POWER
SFP Port 1-24
UTP Port 1-8
UTP Port 1-8
LINK/ACT
Link/ACT
10/100/1000Mbps
Network Interface
Connector
Port
1000Mbps SFP Fiber Module DualMedia Auto Detection
1000Mbps SFP Fiber Module
TP(RJ-45) / SFP
SFP
1 to 8
9 to 24
Hardware Spec.
Voltage
100~240 V
50~60Hz
40W
Frequency
Consumption
Ambient Temperature
Humidity
0 to 40 C
5% to 90%
Dimensions
Weight
44(H) x 442(W) x 209(D) mm
2.9 Kg
Safety
Comply with FCC Part 15 Class A & CE Mark Approval
R
RUB
TECH
Gigabit Switch
Networking & Communications
L2 Plus Managed Switch
Packing Innformmaation
Carton Dimensions (mm)
pcs/Carton
N.W (KG)
G.W (KG)
530x512x345
5
18.5 Kg
19.5 Kg
Orderring IInnformaation
FGS-2924R
16-Port SFP + 8-Port ComboGbE L2 PlusManaged Switch
Optional SFP Module
SFP.LC
1000Base-SX GE SFPFiber Module, LCMulti-Mode 850nm
SFP.LC.M2
1000Base-SX GE SFPFiber Module, LCMulti-Mode 1310nm 2km
Note:
FGS-2924R only supports the SFP transceiver from the following vendors.
1. Ruby Tech Corporation
2. Agilient Technologies
3. AVAGOTechnologies
4. Finisar Corporation
Ruby Tech Corp.
3F, No.1, Lane 50, Nan Kang Road, Sec.3, Taipei, Taiwan
TEL:886-2-2785-3961 FAX:886-2-2786-3012
http://www.rubytech.com.tw
E-mail [email protected]
Technical information listed is subject to change without prior notice. All brand names and trademarks are property of their respective owners.
Copyright c 2008 Ruby Tech Corp. All rights reserved.
|