Rover Trimmer 24750x50A User Guide

38” MODEL 24750x50A & 40” MODEL 24755x50A MULCHER KITS  
HOW TO INSTALL THE MULCHER PLATE  
The mulcher plate and the mulcher blades are optional attach-  
ments that can be added to the mower housing. The mulcher plate  
lets you mulch the grass for a clean, fine cut. Install the mulcher  
plate and the mulcher blades as follows.  
WARNING: To prevent the engine from starting, dis-  
connect the wire from the spark plug. Make sure the  
blade rotation control is in the DISENGAGE position.  
1. Raise the deflector. Slide the front of the mulcher plate under  
the deflector bracket (Figure 1). If necessary, remove grass  
from flange.  
Deflector Bracket  
2. Fasten the mulcher plate with two wingnuts and two carriage  
Mulc
Wingnut  
bolts.  
To discharge the grass out the side, remove the mulcher plate. At-  
tach the fasteners to the mulcher plate for future use.  
Carriage Bolt  
Remove grass  
from flange.  
Figure 1  
Wingnut  
HOW TO REMOVE AND INSTALL THE BLADES  
WARNING: Before you remove the blade, disconnect  
the wire to the spark plug. The blade has sharp  
edges. When you hold the blade, use gloves or cloth  
material to protect your hands.  
Mulcher Plate  
1. Use a piece of wood to keep the blades from rotating.  
2. Remove the nuts that hold the blades (Figure 2).  
3. Remove the standard blades.  
Mandrel  
Blade Adapter  
Hi–Lift Edge  
4. Twomulcher blades are in the mulcher kit. Mount the mulcher  
blades and the blade adapters on the mandrels (Figure 2).  
Right  
Belleville Washer  
Washer  
Nut  
Mulcher Blade  
5. Mount each blade so that the hi–lift edges are up (toward the  
mower housing). If the blade is upside down, the blade will not  
cut correctly and can cause an accident.  
Left  
Mulcher Blade  
Figure 2  
6. Fasten the blades with the original washers and nuts. Make  
sure the outside rim of the Belleville washers are against the  
blades (Figure 3).  
Blade Adapter  
NOTE: Check the rotation of the blades. Make sure the  
blades do not hit the mower housing. If a blade hits, the  
mower housing is bent. Hit the mower housing with a  
hammer until the blade does not touch.  
Blade  
Washer  
Nut  
WARNING: Always keep the nut tight that holds the  
blade. A loose nut or blade can cause an accident.  
Belleville Washer  
(Outside rim must be  
against the blade.)  
7. Tighten the nuts that hold the blades to a torque of 30 foot  
Figure 3  
pounds (41,5N–m).  
F–020904L  
1
 

Raymarine Scanner Radar Scanner User Guide
Reliance Water Heaters Water Heater 184123 000 User Guide
Riccar Vacuum Cleaner GEM R User Guide
Rotel Cassette Player RD 1000M User Guide
Ryobi Blower RY08510 User Guide
Sagem Modem F@ST 800 User Guide
Samsung DVR SHR 7160 User Guide
Samsung Refrigerator RF265AB User Guide
Scientific Atlanta Network Card DPX2213 User Guide
Scytek electronic Remote Starter 2000RS Plus User Guide