Rheemglas® Energy Miser® Direct Vent Gas Water Heaters
now with the Guardian System™
Fury DV
LONGER VENTING AVAILABLE
ꢀAvailable in 50 Gallon Gas Model
6-Year Limited Tank Warranty, 1-Year Limited Parts Warranty*
ꢀ
NEW FVIR Compliant!
Adjustable coaxial vent allows flexibility
of installation – uses outside air for combustion
and requires no electrical power
Aluminum vent and cap base to prevent
staining of building exterior
Anode rod equalizes aggressive water action
High temperature silicone bands reduce venting
installation time
Internal air tube for reduced footprint
Meets ANSI Z21.10.1 requirements for
Flammable Vapor Ignition Resistance (FVIR)
Meets or exceeds National Appliance Energy
Conservation Act (NAECA) requirements
•
•
•
•
•
•
Brass drain valve
•
•
Factory installed temperature and pressure
relief valve
•
R-Foam® insulation for superior heat retention
Exclusive Rheemglas® tank lining resists
corrosion and prolongs tank life
•
•
* See Residential Warranty Information Brochure for complete
warranty information.
Energy Factor based on D.O.E. (Department of Energy) test procedures.
Heat saving flue baffle design
Gas control and combination thermostat
•
•
®
DESCRIPTION
FEATURES
RECOVERY IN
DIMENSIONS
ENERGY INFO.
GAS INPUT IN
FIRST HOUR
DEL. G.P.H.
NAT.
HT. TO
VENT
A
TANK
HT.
B
HT. TO
VENT
SIZE
E
HT. TO
SIDE T&P
F
SHIP.
WT.
(LBS)
ENERGY
FACTOR
NAT.
GALLON
MODEL
THOUS. BTU/HR. G.P.H. 90° RISE
DIAMETER GAS CONN.
CAPACITY NUMBER
C
D
NAT.
NAT.
50
RH DV50FV
38
38.4
80
68
59-1/2 21-3/4
14-1/4
6
52-1/2
165
0.58
ANODE
SIDE VENTING (G)
WITH INCLUDED
VENT KIT
SIDE VENTING (G)
WITH OPTIONAL
VENT KIT
VENTING – ROUGHING IN DIMENSIONS (INCHES)
COLD WATER
CONNECTION
MODEL
4 FEET VENTING
AVAILABLE
OPTIONAL HEIGHT (A)
WITH VENT KIT
NUMBER
MIN.
MAX.
MIN.
MAX.
HOT WATER
CONNECTION
& Vertical
RH DV50FV
Horizontal
8-1/8
18-1/8
8-1/8
48**
68 – 107†
** Horizontal Vent Kit #SP20131. Venting dimensions are approximate.
† Vertical Vent Kit #SP20132. Venting dimensions are approximate.
• If side wall is combustible material, 1" clearance must be included in adjustment range.
10"
E
G
These units are designed
to meet or exceed ANSI
(American National
NEW LONGER VENTING!
• Up to 4 feet above the water heater
and 4 feet from an outside wall.
(G: SIDE VENTING
Standards Institute)
RANGE OF
ADJUSTMENT)
requirements and have been
tested according to D.O.E.
test procedures and meet or
exceed the energy efficiency
requirements of NAECA,
ASHRAE standard 90, ICC
Code and all state energy
efficiency performance
criteria for energy consuming
appliances.
Order Horizontal Vent Kit:
#SP20131
3/4" N.P.T.
RELIEF VALVE
OPENING
Order Vertical Vent Kit:
#SP20132
C
Rheem Exclusive Adjustable
Coaxial Vent Allows Flexibility
of Installation…
You may orient the Fury DV
for easiest service
access, because the
adjustable coaxial
vent can swivel
A
B
F
1/2"
Before purchasing this
appliance, read important
energy cost and efficiency
information available from
your supplier.
D
EXTERIOR
WALL
360 degrees.
In keeping with its policy of continuous progress and product improvement, Rheem reserves the right to make changes without notice.
Rheem Manufacturing Company • Water Heater Division
Rheem Canada Ltd./Ltée, 128 Barton Street West, Hamilton, Ontario L8N 3P3
12/07 WP
FORM NO. 101-22EFCAN Rev1
|