Radio Shack Weather Radio 63 1039 User Guide

Indoor / Outdoor  
Car Thermometer  
Step Three  
Setting the Time  
12V DC  
Adapter  
with Voltmeter  
1. Repeatedly press MODE until the time and  
indoor temperature (IN), or the time and  
outdoor temperature (OUT) appear on the  
display.  
63-1039  
Step One  
Battery Installation  
2. Repeatedly press or hold down HR until  
the correct hour digits appear.  
Sensor Cord  
The thermometer requires two AAA batteries  
(not supplied) for power.  
3. Repeatedly press or hold down MIN until  
the correct minute digits appear.  
Step Two  
Mounting the Thermometer  
1. Slide the battery compartment cover in the  
direction of the arrow to remove it.  
4. To select 12- or 24-hr time format, hold  
down C/F until the time display changes to  
the desired format.  
Place your thermometer on a flat surface inside your car. For measuring  
outdoor temperature, the thermometer's sensor cord extends up to 10 feet.  
2. Insert the batteries as indicated by the  
polarity symbols (+ and –) marked inside.  
Mounting the Bracket  
Step Four  
Using the Thermometer  
1. Clean the desired location inside your car with a soft cloth.  
2. Peel off one side of adhesive paper from the supplied mounting stickers,  
and attach the stickers to the back of the supplied mounting bracket.  
Then, peel off the paper on the other side of the sticker.  
1. Extend the sensor cord and attach the  
sensor to the outside of your car.  
2. Repeatedly press MODE until the time and  
outdoor temperature (OUT), outdoor  
3. Replace the battery compartment cover.  
3. Firmly press the bracket onto the desired car location.  
4. Slide the thermometer onto the bracket.  
Mounting the Sensor  
temperature (OUT) and voltage (V), or  
outdoor temperature (OUT) and indoor  
temperature (IN) appears on the display.  
What’s Included  
• Indoor/Outdoor Thermometer  
Adapter  
3. Repeatedly press C/F to select Celsius or  
Fahrenheit. The current temperature (IN or  
OUT, depending on your display view)  
appears.  
1. Peel off the paper from the back of the sensor to expose the adhesive  
tape.  
Mounting Bracket  
Mounting Stickers (2)  
Voltmeter  
2. Firmly press the sensor against a clean, flat surface on the outside of  
your vehicle.  
 

Radio Shack Cordless Telephone 43 3529 User Guide
Radio Shack Cordless Telephone ET 926 User Guide
RCA VCR VR725HF User Guide
RIDGID Saw MS1250LZA User Guide
Rosewill Wheelchair RCTO4BF User Guide
Samsung All in One Printer All in One Printer User Guide
Samsung Car Stereo System LTN325W User Guide
Sanyo Toaster SK 7S User Guide
Sears Electric Heater 58335601 User Guide
Sears Plumbing Product 42 34713 User Guide