Radio Shack Handheld TV 16 3009 User Guide

EAR Jack - Lets you enjoy  
private listening with an optional  
earphone.  
External Antenna  
If you are in an area with weak TV signals, or  
inside a metal or concrete building, you might  
need an external antenna to improve reception.  
EXT. ANT. Jack - Lets you  
connect an external antenna for  
optimum reception in weak  
signal areas.  
Flat LCD - makes the TV more  
compact and uses less power  
than a standard picture tube.  
2.3” LCD TV  
16-3009  
Connect the antenna to the EXT. ANT. jack. If  
your antenna wire is 75-ohm coaxial cable, use  
an F-to-mini plug adapter to complete the  
connection. If you have 300-ohm wire, use a  
300-to-75 ohm mini plug adapter. Both are  
available at your local RadioShack store.  
Volume - Turn the dial to adjust  
the volume level.  
Bright - Turn dial to adjust the  
brightness level.  
Power  
BATTERY POWER  
Your TV requires four AA batteries (not supplied).  
You may purchase alkaline batteries from your local  
RadioShack store.  
Tuning Ý /Þ - Turn dial to adjust  
the picture to the desired television  
channel.  
EXT. ANT. Jack  
Use the stand to lean the TV  
against flat surfaces.  
1. Slide off the battery compartment cover.  
2. Insert the batteries into the compartment  
(three above and one below) as indicated by the  
polarity symbols (+ and –) marked inside.  
3. Replace the cover.  
Notes:  
The TV can operate for about 4 hours with alkaline batteries. When the sound level  
lowers or the picture becomes unstable, replace the batteries.  
The TV’s internal batteries automatically disconnect when you connect an adapter.  
Using Your TV  
1. Extend the rod antenna and slide UHF/VHF/OFF to VHF or UHF. The TV starts scanning and stops at the next active channel  
AC POWER  
in the selected band.  
Built-in Rod Antenna  
You can power the TV using a regulated 6V AC adapter of at  
least 500 mA, and a size B Adaptaplug™ adapter (neither  
supplied). Both are available at your local RadioShack store.  
2. Press  
TUNING  
below the screen.  
to tune to a different channel. The tuning line on the screen aligns with the selected channel number  
3. To adjust the volume, rotate VOLUME located on the right side of the TV.  
Settheadapter’svoltageswitchto6V. InserttheAdaptapluginto  
the adapter’s cord, aligning + with TIP. Plug the Adaptaplug’s  
barrel plug into the TV’s DC IN 6V jack. Then plug the other end  
of the AC adapter cord into a standard AC outlet.  
4. To adjust the picture to the desired brightness, rotate BRIGHT located on the right side of the TV. The brightness also  
changes with the screen’s angle.  
UHF/VHF/OFF  
DC IN 6V Jack  
BACKLIGHT  
In low temperatures, the TV screen takes a few seconds to light, or it might be slightly red  
in color. This is not a malfunction. Normal operation resumes after a few seconds.  
Note: The adapter might become warm after extended periods  
of use.  
USING AN EARPHONE  
For private listening, you can connect an optional earphone with a 1/8-inch plug to the EAR  
USING VEHICLE BATTERY POWER  
jack. This automatically mutes the built-in speaker.  
You can power the TV from a vehicle’s 12V power source (such as a cigarette-lighter  
socket) using a 6V, 500-mA DC adapter and a size B Adaptaplug™ adapter (neither  
supplied). Use an optional DC adapter to power the TV from a vehicle’s cigarette-lighter  
socket if the vehicle has a 12V DC, negative ground electrical system.  
EAR Jack  
Cautions:  
Set VOLUME to the lowest setting before you begin listening. Then adjust the volume to a comfortable level.  
Do not use an earphone when operating a vehicle or riding a bicycle. This can cause a traffic hazard and can be illegal in  
some areas.  
Set the adapter’s voltage switch to 6V. Insert the Adaptaplug into the adapter’s cord,  
aligning + with TIP. Plug the Adaptaplug’s barrel plug into the TV’s DC IN 6V jack. Unplug  
the vehicle’s cigarette lighter and plug the large end of the DC adapter cord into the  
cigarette-lighter socket.  
Optional Accessories  
Note: If the TV does not operate properly when you use DC power, be sure the cigarette-  
lighter socket is clean and that the adapter’s plug is properly connected to the socket.  
Earphones  
Size B Adaptaplug  
6V Vehicle DC Adapter  
6V AC to DC Adapter Alkaline Batteries  
 

RCA Cordless Telephone 27910 User Guide
Roadmaster Car Speaker RS630 User Guide
RocketFish Computer Drive RF ICAP12 User Guide
Roland Printer PC 600 User Guide
Salton Stereo System SD8SR User Guide
Samsung Bluetooth Headset WEP500 User Guide
Samsung DVD Player AH68 00442F User Guide
Samsung Printer SRP 270 Series User Guide
Samsung Refrigerator Model RS27KLMR User Guide
Sanyo Flat Panel Television CE26LC81 B User Guide