Radio Shack Bicycle 60 4353 User Guide

Recreate all of your favorite Ricky  
Carmichael moves by adjusting the  
head, arms and legs, while racing up to  
an impressive 20 m.p.h.!  
Honda CR250R Motocross Bike featuring Ricky Carmichael  
60-4353  
6WHSꢀ7ZR  
:KDW·Vꢀ,QFOXGHG  
Installing the Antenna  
Honda CR250R Motorcycle Transmitter  
Ricky Carmichael Action Figure Display Stand Antenna Tube  
Two 4-Way Wrenches Three Allen Wrenches Owner’s Manual  
Route the loose end of the motorcycle’s antenna wire through the supplied antenna tube.  
• Insert the tube securely into the motorcycle’s tube holder.  
Extend the transmitter’s antenna to its full length before driving the motorcycle. For maximum range, hold the transmitter  
with the antenna as high as possible and point it straight up.  
Retract the transmitter’s antenna when you are finished driving the motorcycle.  
6WHSꢀ2QH  
Installing Batteries  
You will need...  
Four AA batteries for the motorcycle  
One 7.2V rechargeable Ni-Cd or Ni-MH battery pack  
(not included)  
One battery charger (not included)  
One 9V battery for the transmitter (not included)  
Phillips screwdriver (not included)  
6WHSꢀ7KUHH  
Driving the Motorcycle  
Steering  
Wheel  
Trim  
F/R  
Trim  
ST  
LED  
Trim Controls  
Turn the motorcycle and transmitter on. The LED lights on the transmitter.  
OFF/ON  
Switch  
Position the motorcycle straight and upright, holding the back of the seat and lifting the real wheel  
off the ground. Be sure to find a large open area with no cars or curbs to run the motorcycle.  
TRIM VOL F/R - Adjusts  
the throttle so the  
motorcycle stops  
Put AA Batteries in the Motorcycle  
Pull the transmitter’s throttle trigger to full speed and release the motorcycle.  
Warning: Keep your fingers away from the spinning tire.  
When you finish driving, turn the motorcycle off first, and then turn the transmitter off. See Page 2  
for Driving Tips.  
completely when you  
release the trigger. If the  
trim is not set properly, the  
motorcycle might continue  
to move forward when you  
release the trigger.  
Loosen the screw on the battery  
box cover, located on the seat of  
the motorcycle, and remove the  
cover.  
Take out the battery holder and  
insert four AA batteries, matching  
the polarity symbols (+ and -)  
marked inside.  
Replace the battery holder and  
cover, and then secure it with the screw.  
Transmitter Controls  
TRIM VOL ST - Adjusts  
the wheel alignment so  
the motorcycle drives in a  
straight line when you  
release the steering  
wheel.  
Throttle Trigger  
Throttle Trigger - Pull the trigger back toward the grip to move forward. Release the trigger to stop.  
Throttle Trigger Brake - The throttle trigger is used to slow the motorcycle down also. Push the  
trigger forward away from the grip to apply the brake and reduce speed.  
Steering Wheel - Steer the wheel left to go left. Steer the wheel right to go right. Release the  
wheel to go straight.  
Put 7.2V Rechargeable Battery Pack in Motorcycle  
Loosen the screw on the battery compartment cover, located  
on the bottom of the motorcycle,  
and remove the cover.  
9V Battery Chamber  
Place the battery pack in the  
compartment, attachingthebattery  
pack’s white plastic connector to  
the motorcycle’s matching  
Adjusting the Trim Controls  
Cool Stunts  
Adjust the trim controls to make the motorcycle drive properly.  
When driving at a medium or high  
speed, the motorcycle may raise  
the front tire off the ground if you  
drive on a surface that has small  
bumps or obstacles.  
connector. Do not force them  
together. They only fit one way.  
Throttle Trim  
Place your motorcycle on the display stand so the rear wheel does not  
touch the ground.  
Turn the transmitter and motorcycle on.  
• If the rear wheel moves, turn the TRIM VOL F/R on the transmitter  
clockwise or counter-clockwise until the wheel stops.  
Replace the cover and secure it  
with the screw.  
To fish tail the motorcycle, start  
making a turn at a low speed. Then,  
immediately change the direction of  
the turn and increase the speed.  
Put 9V Battery in the  
Transmitter  
Warning: Never use the throttle trim to make the motorcycle go.  
Remove the battery  
compartment cover.  
• Insert the battery in  
the transmitter,  
matching the polarity  
(+ and -) symbols  
marked inside.  
You can perform jumps with your  
motorcycle off ramps that are eight  
inches high or less.  
Steering Trim  
If your motorcycle does not drive in a straight line, turn the TRIM VOL ST left  
or right until your motorcycle moves in a straight line. Release the steering  
wheel before you make the adjustment.  
Hint: When transporting your motorcycle, do not pick it up by the driver’s head. Use both hands to support  
the motorcycle, one holding the front fork and the other holding the rear of the seat.  
Replace the cover.  
 

PYLE Audio TV Video Accessories PAVS008 User Guide
RCA Portable Multimedia Player M63 Series User Guide
Recoton Advent Stove U31 LP2 User Guide
RocketFish Computer Hardware RF PHD35 User Guide
Roland Musical Instrument HPi 7 User Guide
Rolls Stereo Amplifier AMA2152 User Guide
Rosen Entertainment Systems DVD Player AC3003 User Guide
Samsung All in One Printer SLM3320ND User Guide
Sanyo Webcam VPCX1220EX User Guide
Scientific Atlanta Modem DPX2203TM User Guide