Quantum Computer Drive Atlas III User Guide

Atlas III  
Mounting Guidelines  
Mounting Guildelines  
The mounting holes on the Maxtor Atlas III 9.1/18.2GB hard disk drive allow  
the drive to be mounted in any orientation. Figure 1-1 identifies the location of  
the three mounting holes found on each side of the drive and the four mounting  
holes found on the PCB side of the drive. Dimensions given are in inches.  
Mounting Screw Clearance  
Please note that the printed-circuit board assembly (PCBA) is very close to the  
mounting holes. For mounting #6-32 UNC screws are recommended. Mounting  
screws should be no longer than 0.25 inches (6.25 mm) and maximum torque  
applied to the screws must not exceed 14 inch-pounds (1.57 N-m). clearance  
from the drive to any other surface (except mounting surfaces) must be a  
minimum of 0.05 inches (1.25 mm).  
Ventilation  
The Maxtor Atlas III 9.1/18.2GB hard disk drive operates without a cooling fan,  
provided the ambient air temperature does not exceed 131°F (55°C). Clearance  
from the drive to any other surface above and below must be a minimum of  
1/16 inch (1.25 mm) to allow airflow.1/16 inch (1.25 mm) to allow airflow.  
1 of 1  
 

Q See DVR MODEL QC40196 User Guide
Quatech TV Converter Box SSU2 400I User Guide
RCA Switch DH3HSL User Guide
Rockford Fosgate Speaker R1S410 User Guide
Rolls Stereo Amplifier RA63s User Guide
Rubbermaid Outdoor Storage 1S85 User Guide
Samson DJ Equipment MDR series User Guide
Samsung Personal Computer DP700A3D A01US User Guide
Samsung Printer ML 1750 User Guide
Sanyo Air Conditioner 09AHX52 User Guide