PYLE Audio TV Mount PSWLE58 User Guide

INSTALLATION GUIDE  
Item No.:PSWLE58  
Thank you for choosing our product  
Pyle Audio  
1600 63rd st , Brooklyn, NY, 11204  
(718)236-8000  
TV Size Range: 23"~42"  
Maximum Weight Capacity: 20kg/44lbs  
Locking by locking bar on the bottom  
Warning  
This product contains small items that could be a choking hazard if swallowed. Keep  
these items away from young children!  
1.Make sure these instructions are read and completely understood before attempting  
installation. If you are unsure of any part of this installation, contact a professional  
installer for assistance.  
www.pyleaudio.com  
CAUTION  
2.The wall or mounting surface must be capable of supporting the combined weight of  
the mount and the display; otherwise the structure must be reinforced.  
3.Safety gear and proper tools must be used. A minimum of two people are required  
for this installation. Failure to use safety gear can result in property damage, serious  
injury or death.  
This product was designed to be installed on wood stud walls and solid concrete walls.  
Before installing make sure the supporting surface will support the combined load of the  
equipment and hardware. Never exceed the Maximum Load Capacity. This product is  
intended for indoor use only. Use of this product outdoors could lead to product failure or  
personal injury.  
-8-  
 
Part 3-MMountinng the flat panel screen  
Partt 1aa-Woodd SStud Mouunting  
2,3  
Hook the top of brackets(2,3) onto the top flange  
of wall plate(1). Then swing the screen down.  
Use wall plate(1) as a template, make sure it is level, and mark four mounting  
holes along the center lines of the wood studs. Drill four 3/16(5mm)dia.  
holes 2(50mm) deep. Level wall plate(1) and attach to wall with four long  
bolts(F) and four washers(H). Tighten screws firmly. Do not overtighten.  
NOTE: Always use an assistant or mechanical  
lifting equipment to safely lift and position  
heavy equipment.  
1
Use the Locking bar(4) to prevent the TV from being removed or  
accidentally knocked off of the wall plate.When the locking bar half  
insertes into the wall plate , you can use the rotating rod(5) to make it  
fully inserted.  
5
Stud finder  
Wood stud  
4
H
2(50mm)  
F
Φ3/16(5mm)  
-3-  
-6-  
 
Part 2-Atttachingg BBrackets TTo Screen  
Part 1b--Concrette Wall MMoounting  
Center brackets vertically on back of screen. Select the small(A or B) or  
medium(C or D) screw. Attach brackets to screen using four selected screws  
and four square washers(E) at the top and bottom of each bracket. Tighten  
screws firmly. Do not overtighten.  
Level wall plate(1) and use wall as a template to mark four holes. Drill four 3/8”  
(10mm) dia. holes 2(50mm) deep. Insert four anchors(G) into holes and  
secure wall plate with four long bolts(F) and four washers(H).Tighten screws  
firmly. Do not overtighten.  
E
Square washer(E)  
2(50mm)  
A-D  
Φ3/8(10mm)  
Medium hole for  
M5 and M6 screws  
Small hole for  
M4 screws  
Concrete Wall  
G
H
F
-5-  
-4-  
 

QSC Audio Stereo System DSP0002 User Guide
Raypak Boiler 0042B User Guide
Rheem Water Heater 92 103234 02 User Guide
Roland Recording Equipment VC 2 User Guide
Roland Stereo Equalizer BR 864 User Guide
Rosewill Network Card RC201 User Guide
Rotel CD Player RCD 06 User Guide
Samsung Computer Hardware PCA 6189 User Guide
Samsung Printer ML 1630 User Guide
Sanyo Battery Charger UPF386369 User Guide