Kambrook Hair Clippers KHC10B User Manual

Hair Clipper Kit  
 
KHC10B  
Issue 1/01  
Do not use the hair clipper with a  
damaged or broken comb nor with teeth  
missing from the blades, to avoid injury.  
the extension cord or power board  
should be positioned so that is not subject  
to splashing or contact with moisture.  
Use this hair clipper only as described  
in this instruction book.The use of  
attachments not recommended by the  
manufacturer may cause a hazard.  
The installation of a residual current  
(RCD) is recommended to provide  
additional safety protection when using  
electrical appliances, It is also advisable  
that a RCD with a rated residual  
operating current not exceeding 30mA be  
installed in the electrical circuit supplying  
the bathroom. See your electrician for  
professional advice.  
Keep blades regularly oiled and clean  
blades after each use.  
If the appliance is connected to an  
extension cord or power board then  
Features OfYour Kambrook Hair Clipper  
Adjustable blade  
control lever for  
close trimming and  
finishing off  
Blade guard – protects  
blade when not in use  
particularly around  
the neck and ears.  
Barber’s scissors – quality  
stainless steel blades  
On/Off switch  
Easy hold clipper  
Barber’s comb – for  
precision cutting control  
#4  
#3  
#2  
#1  
Blade brush – for cleaning  
the cutting blades after use  
Trim guide # 1 – for short hair  
Trim guide # 2 – for medium hair  
Lubricating oil – to keep  
blades in peak condition  
Trim guide # 3 – for medium – long hair  
Trim guide # 4 – for longer hair  
3
 
Before using the hair clipper, make sure  
the blades are clean and well oiled.  
Unwind the cord to its full length, ensure  
that the on/off switch is off ‘O’ and plug  
the cord into a 230 /240V power outlet,  
then turn the power on.  
Gently lift the tab at the other end of the  
attachment comb and push down until a  
click is heard.  
Operate the hair clipper with the  
ON/OFF switch.  
NOTE: For uniform cutting, never push or force the  
hair clipper through the hair at a fast speed.The  
hair clipper works most efficiently when it works at  
its own speed.  
Adjustable Lever  
Attachment Comb #1 – leaves hair  
approx. 3mm (1/8") in length  
Attachment Comb #2 – leaves hair  
approx. 6mm (1/4") in length  
Attachment Comb #3 – leaves hair  
approx. 9mm (3/8") in length  
Attachment Comb #4 – leaves hair  
approx. 12mm (1/2") in length  
The adjustable lever adds versatility to  
your hair clipper by allowing you to  
gradually change the closeness of your cut  
without using an attachment comb.  
Initially cut only a small amount of hair  
until you become accustomed to the  
length each attachment comb leaves the  
hair.  
When the lever is in the uppermost  
position, the blade will give you the  
closest cut.To increase the cutting length,  
push the lever downward gradually.  
It is suggested to try the longest  
attachment comb on the hair clipper first,  
then use the shorter one if a shorter  
length is desired.  
The lever extends the variety of lengths  
that can be achieved with each attachment  
comb, by using the varying cutting edges  
with each attachment comb.  
Attachment Combs  
Attachment combs should be fitted to  
hair clipper by placing the top edge (comb  
edge) of the attachment comb over the  
top of the cutting blades.  
4
 
UsingYour Kambrook Hair  
Clipper  
4. If you desire shorter hair, either change  
to a lower number attachment comb or  
apply more pressure and less lift away  
from head with the present attachment  
comb.  
1. Place a towel around the neck of the  
person to prevent hair from falling down  
inside the collar.  
2. Position the person in a chair so that  
his/her head is at your eye level.  
5. For the top of the head, you will give a  
fairly short cut if you use the #4  
attachment comb.With the teeth flat  
against the head, slowly start trimming  
from the front to the back. (Diagram A-4)  
3. Comb the hair to remove all the  
tangles, hold the clipper in a relaxed,  
comfortable grip to help you maintain  
accurate cutting control.  
4. Before using the clipper ensure that the  
blades are free of any hair clippings and  
the blades are well oiled. (See Maintaining  
Your Kambrook Clipper on page 6)  
Note:The entire procedure requires practice, and it  
is always better to leave the hair longer in the first  
few haircuts.  
Outlining  
Medium to Long Cut  
(with attachment combs)  
B-1  
B-2  
A-1  
A-2  
A-3  
A-4  
1. Outlining requires no attachment comb.  
Take the hair clipper and push the  
lever up to the close – cut position  
1. Start by combing the hair in its natural  
direction.  
2. Place the largest attachment comb  
onto the hair clipper and start by  
trimming the sides from the bottom  
upwards. Hold the hair clipper lightly  
against the hair with the teeth of the  
attachment comb pointing up but flat  
against the head. Slowly lift the hair  
clipper up and outward through the hair,  
cutting only a small amount at a time.  
(Diagram A-1)  
(see “adjustable lever).  
2. Comb hair into the style. Position hair  
clipper between the side burns and the  
ear. (Diagram B-1)  
3. Make sure the corner edge of the blade  
is up against the hairline.With the outline  
of the hair as your guide, slowly move the  
hair clipper over, around and behind the  
ears. (Diagram B-2)  
4. For the back of the neck and side  
burns, hold the clipper up side down, and  
holding it against the skin at the length  
desired, move downwards.  
3. Repeat around sides and back of head.  
(Diagram A–2 & A–3)  
5
 
Short Cuts to Perfect FlatTops,  
Crew Cuts  
MaintainingYour Kambrook  
Hair Clipper  
Cleaning  
After you have finished using your hair  
clipper rapidly move the adjustable lever  
up and down a couple of times while the  
hair clipper is still running, to remove any  
hair that may be caught in between the  
blades.Then switch off the appliance and  
power outlet.Then unplug your hair  
clipper and clean the blades with the  
brush supplied.  
C-1  
C-2  
C-3  
Oiling  
To maintain the hair clipper in peak  
condition, the blades should be regularly  
oiled before, during and after every  
haircut.A substitute/replacement for the  
clipper oil supplied in the kit is household  
sewing machine oil.  
C-4  
1.Always cut from the back of the neck to  
the crown, using the longest attachment  
comb. Holding it flat against the head,  
slowly move the hair clipper up through  
the hair. (Diagram C-1)  
NOTE: Do not use hair oil, grease, oil mixed with  
kerosene or solvent, as the solvent will evaporate  
and leave the thick oil, which may slow down the  
blade motion.  
2. Use the same technique for the sides,  
cutting from the bottom to the upper side  
of the head.  
To oil the blades, gently squeeze a few  
drops of oil between the blade teeth and  
turn the clipper on, checking that the  
clipper is running smoothly.  
3. From the front to the crown, cut the  
hair against the direction in which it  
grows.Then even it up with the sides.  
(Diagram C-2)  
4. For a flat top, use a normal flat comb  
and cut hair on top of the head over it.  
5.To taper hair down to the neckline, use  
closer cutting attachment combs. Comb  
hair and check for uneven spots and  
outline sideburns and neckline. (Diagram  
C-3)  
If the blades are dulled and have stopped  
cutting, replace them with new blades  
from your nearest Kambrook service  
centre.  
6. If a short tapered cut on the sides and  
back is desired, follow the diagram below  
and change attachments as illustrated.  
(Diagram C-4)  
6
 
KAMBROOK  
12 MONTH  
REPLACEMENT WARRANTY  
If the product includes one or a number of  
accessories only the defective accessory  
or product will be replaced.  
KAMBROOK warrants the purchaser  
against defects in workmanship and  
material, for a period of 12 months from  
the date of purchase (3 months  
commercial use).  
In the event of KAMBROOK choosing to  
replace the appliance, the guarantee will  
expire at the original date, ie. 12 months  
from the original purchase date.  
Guarantee and purchase receipt for this  
product are to be retained as proof of  
purchase and must be presented if making  
a claim under the terms of the  
In Australia, this KAMBROOK Guarantee  
is additional to the conditions and  
guarantees which are mandatory as  
implied by the Trade Practises Act 1974  
and State Territory legislation.  
KAMBROOK guarantee.  
KAMBROOK reserves the right to  
replace or repair the appliance within  
the warranty period.  
For service, spare parts or product  
information in Australia, please call  
KAMBROOK on the customer Service  
Line (free call) 1800 800 634.  
Warranty does not apply to any defect,  
deterioration, loss or injury or damage  
occasioned by, or as a result of the misuse  
or abuse, negligent handling or if the product  
has not been used in accordance with the  
instructions.The guarantee excludes  
breakages and consumable.  
For service, spare parts or product  
information in New Zealand, please  
call KAMBROOK New Zealand, Mono  
Place, Ellerslie,Auckland.  
Phone 0800 253 007, FAX 0800 263 001.  
This warranty is void if there is evidence  
of the product being tampered with by  
unauthorised persons.  
If claiming under this guarantee the product  
must be returned to freight prepaid.  
YOUR PURCHASE RECORD (Please complete)  
Attach purchase receipt here.  
DATE OF PURCHASE______________________________________________________  
MODEL NUMBER ________________________________________________________  
SERIAL NUMBER (If applicable) ______________________________________________  
Please don’t return purchase record  
unless you are making a claim  
PURCHASED FROM ___________________________
 
Issue 1/01  
Kambrook 4 Kingston Town Close Oakleigh,Victoria 3166,Australia  
Customer Service Line (free call) 1800 800 634 Customer Service Fax 1800 621 337  
Kambrook (New Zealand) Mono Place Ellerslie,Auckland, New Zealand  
Customer Service Line/Spare Parts 0800 253 007 Customer Service Fax 0800 263 001  
Due to continual improvement in design or otherwise, the product you purchase may differ slightly from the one illustrated in this book. Issue 1/01  
 

Ingersoll Rand Air Cleaner 16574303 User Manual
Jacuzzi Hot Tub Y950 User Manual
Jenn Air Refrigerator JCD2297KEF User Manual
KEF Audio Portable Speaker Ci50R User Manual
Kenmore Dishwasher 6651404 User Manual
Kenmore Freezer 29701 User Manual
Keys Fitness Home Gym 530U User Manual
KitchenAid Range KERA807P User Manual
KitchenAid Ventilation Hood KWCU300L User Manual
Korg Musical Instrument PXR4 User Manual