Jenn Air Cooktop JED4536W User Manual

JENN-AIR® DETAILED PLANNING DIMENSIONS  
1 of 4  
36" Jx3ELEcTRIc RADIANT DOwNDRAfT cOOkTOP wITh ELEcTRONIc TOuch cONTROL  
JED4536W – 3512" x 1838" x 2218"  
PRODucT DIMENSIONS  
A
MODEL #  
JED4536W  
in  
cm  
Overall width  
Euro-Style Stainless  
3512  
3538  
90.0  
89.8  
A
B
Floating Glass  
B
Overall depth  
Euro-Style Stainless  
2218  
22  
3438  
1212  
1838  
378  
56.2  
55.9  
87.3  
31.8  
46.8  
10.0  
22.0  
0.6  
Floating Glass  
Width of recessed cooktop  
C
D
E
F
TOp VIEW  
Width of blower motor assembly  
Height from blower motor to countertop  
Height of recessed cooktop  
Height from electrical housing to countertop  
Height of cooking surface  
858  
G
H
I
14  
A
Depth of recessed cooktop  
21  
1678  
53.4  
42.8  
H
C
Height from plenum to countertop  
J
F
G
E
D
FRONT VIEW  
B
I
J
E
SIDE VIEW  
Product dimension, cutout and installation specifications are provided for planning purposes only. Before installing  
any product, be sure to verify cutout dimensions and electrical/gas connections as actual product dimensions may vary.  
JRC120014A 07/2012  
 
JENN-AIR® DETAILED PLANNING DIMENSIONS  
3 of 4  
DucT-fREE kIT  
JDA7000WX – 1758" x 1038" x 712"  
Jx3DOwNDRAfT cOOkTOPS wITh DucT-fREE VENTILATION  
The duct-free filter kit (JDA7000WX) is approved for use with JX3™ downdraft cooktop models  
JGD3536W, JGD3430W, JED4536W, JED3536W, JED4430W and JED3430W. The kit filters the air  
from the downdraft system and ventilates the conditioned air into the room through the toe kick  
of the base cabinet. Do not ventilate the air from the downdraft system into the base cabinet,  
base cabinet pedestal, crawl space, wall or attic.  
PRODucT DIMENSIONS  
MODEL #  
JDA7000WX  
in  
1758  
1038  
712  
3
cm  
44.7  
26.5  
19.0  
7.6  
Width of housing  
A
B
C
D
E
Height of housing  
Depth of housing  
Minimum height of toe kick  
Minimum depth to toe kick  
B
212  
6.4  
A
EXHAuST CuTOuT LOCATION  
The cutout location in the toe kick area of the cabinet floor is  
dependent upon the dimensions of the cooktop and base cabinet.  
FRONT VIEW  
C
Airflow  
D
Floor  
E
SIDE VIEW  
Product dimension, cutout and installation specifications are provided for planning purposes only. Before installing  
any product, be sure to verify cutout dimensions and electrical/gas connections as actual product dimensions may vary.  
JRC120014A 07/2012  
 
JENN-AIR® DETAILED PLANNING DIMENSIONS  
4 of 4  
DOwNDRAfT cOOkTOP DucTING ARRANGEMENTS  
The diagrams below show typical duct arrangements for downdraft cooktops. JX3™ downdraft cooktops  
also offer a duct-free installation option. For more details, refer to page 3.  
DucTING cONfIGuRATIONS  
DucTING REQuIREMENTS  
Roof jack  
COOKTOp  
DuCT LENGTH  
DuCT SIzE  
5" (12.7 cm)  
diameter*  
10' (3.0 m) or less*  
6" (15.2 cm)  
diameter  
314" x 10"  
Gas  
314" x 10"  
(8.3 cm x 25.4 cm) duct –  
54' (16.5 m) max.  
Between 10' (3.0 m)  
and 60' (18.3 m)  
(8.3 cm x 25.4 cm)  
5" (12.7 cm)  
diameter**  
10' (3.0 m) or less**  
6" (15.2 cm)  
diameter  
314" x 10"  
Electric  
Between 10' (3.0 m)  
and 60' (18.3 m)  
Transition elbow  
(8.3 cm x 25.4 cm)  
*Gas cooktops must use 5" (12.7 cm) diameter for runs of 10' (3.0 m) or less.  
**May be used to vent straight out the back of the cooktop and directly  
through the wall.  
CALCuLATING MAXIMuM DuCTING LENGTH  
• Maximum ducting length is 60' (18.3 m).  
• Each 90° elbow equals 5' (1.5 m) duct.  
• Use no more than three 90° elbows.  
REAR DuCTING IN WALL TO ROOF  
• Flexible metal vent is not recommended.  
• Do not install two elbows together.  
NOTES:  
• For ducting runs up to 30' (9.1 m), install cooktop as shipped.  
• For ducting runs of 31' (9.4 m) to 60' (15.2 cm), remove the  
restricter ring on the blower inlet housing.  
• For altitudes above 4500' (1272.0 m), reduce recommended  
vent run by 20% for best performance.  
REAR DuCTING THROuGH WALL TO OuTSIDE  
6" (15.2 cm) diameter duct –  
5112' (15.7 m) max.  
5" (12.7 cm ) to 6" (15.2 cm)  
diameter transition  
Transition elbow  
314" x 10"  
(8.3 cm x 25.4 cm) duct  
6" (15.2 cm)  
diameter elbow  
6" (15.2 cm)  
diameter wall cap  
SIDE DuCTING IN TOE KICK TO OuTSIDE  
THROuGH FLOOR BETWEEN JOISTS TO OuTSIDE  
Product dimension, cutout and installation specifications are provided for planning purposes only. Before installing  
any product, be sure to verify cutout dimensions and electrical/gas connections as actual product dimensions may vary.  
JRC120014A 07/2012  
 

Insignia CRT Television NS 20FTV User Manual
Jackson Dishwasher AJ 64 User Manual
Jacuzzi Hot Tub EG90 User Manual
Jasco Universal Remote RM24970 User Manual
JBL Speaker System SCS120 User Manual
Juniper Networks Network Router V10000 User Manual
JVC CD Player KD AR770 User Manual
Kenmore Oven 318201516 User Manual
Kenwood GPS Receiver DNX5360 User Manual
King Canada Vacuum Cleaner 8520LP User Manual